Advertisement
Available languages
Available languages
FCC/IC Statement
This device complies with Part 15 of the FCC
Rules / Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following
two conditions:
(1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance
could void the user's authority to operate the
equipment.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates uses and
can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved
for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the
antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for
successful communication.
MPE Requirements
To satisfy FCC / IC RF exposure requirements,
a separation distance of 8 inches (20 cm) or more
should be maintained between the antenna of
this device and persons during device operation.
To ensure compliance, operations at closer than
this distance is not recommended.
Warnings
• Do not use in or around water.
• Use only the recommended voltage and
frequency requirements.
• Keep out of the reach of children.
• Do not operate light with wet hands.
• Keep lamp away from hot objects.
• Do not incinerate.
• Do not crush.
• Use Only three-wire outdoor extension
cords that have three-prong grounding plugs
and grounding receptacles that accept the
appliance's plug.
• Ground Fault Circuit Interrupter (GFCI)
protection is to be provided on the circuit(s)
or outlet(s) to be used for the wet location
portable luminaire. Receptacles are available
having built-in GFCI protection and are able to
be used for this measure of safety.
• Use only with an extension cord for outdoor
use, such as an extension cord of cord type
SW, SW-A, SOW, SOW-A, STW, STW-A, STOW,
STOW-A, SJW, SJW-A, SJOW, SJOW-A, SJTW,
SJTW-A, or SJTOW, SJTOW-A.
Warning: When using outdoor use portable
luminaries, basic safety precautions should
always be followed to reduce the risk of fire,
electric shock, and person injury.
3
Advertisement
