Table of Contents
Advertisement
5.
Starting: Press the ON/OFF Button to turn on
6.
Selecting Speeds: To customize your dermaplaning session,
provides a choice of 3 power/intensity settings (low, medium and high). We
recommend that you start on a lower speed setting and gradually increase
power/intensity as you get used to sonic dermaplaning.
After pressing the on/off button one time the unit will power on in low speed.
When you press the button again, the unit will change to medium speed.
Pressing the power button a third time will change the speed to high and
pressing the button one more time will shut off the device.
Through smart technology, if you hold the power button down for 2 seconds in
your favorite speed setting, the unit will power off and remember your favorite
setting the next time you power on the device. For example, when the unit is
powered on in medium speed setting, hold the button down for two seconds
to power off the device. When you press the button one time to power on the
device, the handle will power on in the medium speed setting
7.
Sonic Dermaplaning. After prepping your complexion with the degreasing
cleanser in the lavender tube, rinsing clean and patting skin dry, you are ready
to begin your session. There is no wrong way to dermaplane but if you would
like to mimic the pattern your aesthetician uses to perform a dermaplane
session, follow the tips below.
Caution: Pull hair back away from face and take precaution when using
around hairline and eyebrows.
sonicsmooth
sonicsmooth
| 9
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Sonicsmooth and is the answer not in the manual?
Questions and answers
good morning, why does my device no longer hold charge more than a few minutes? device is left in charging every day and should be fully charged.
The Michael Todd Sonicsmooth device may no longer hold a charge for more than a few minutes due to improper charging habits or battery degradation. If the device is rarely used, it should be recharged every three months to maintain its charging capability. Additionally, if the device is not seated properly in the Charging Cradle, it will not receive a charge. If the issue persists, the device should be charged for a minimum of five hours. If this does not resolve the problem, contacting Customer Service is recommended.
This answer is automatically generated
How to reset battery cradle or inspect it for not charging. Unit is only 6 mos old and barely used. This was a gift thru Amazon and never registered for the warranty.
To inspect and reset the battery cradle for charging issues with the Michael Todd Sonicsmooth:
1. Check the Placement: Ensure the Sonicsmooth handle is sitting properly in the Charging Cradle. If it is not positioned correctly, it will not receive a charge.
2. Inspect the Charge Indicator:
- A green Power Light means the charge is good.
- A red Power Light indicates a low charge.
- If the Power Light flashes red, the device will power off after 10 minutes of use.
3. Recharge the Device: If the Sonicsmooth stops working, place it in the Charging Cradle for at least 5 hours.
4. Avoid Water Damage: Do not immerse the Charging Cradle in water, as it may cause malfunctions.
5. Contact Customer Service: If the issue persists after charging for 5 hours, reach out to Customer Service for assistance.
This answer is automatically generated
I put the smooth head on by mistake. I can't get it off so I can use the blade
To remove the smooth head from the Michael Todd Sonicsmooth and use the blade, slide the device handle through the opening in the cartridge case along the Safety Edge tracks until the Safety Edge clicks into place. Use your pointer finger to hold the Safety Edge in place during attachment. Once secured, lift the device and attached Safety Edge from the cartridge.
This answer is automatically generated