Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Copland CTA408
Summary of Contents for Copland CTA408
- Page 1 COPLAND CTA408 USER GUIDE...
- Page 2 What’s in the Box KT150 POWER TUBES POWER CORD REMOTE CONTROL USER GUIDE USER GUIDE AMPLIFIER...
-
Page 3: Getting Started
GETTING STARTED Open the carton and remove the amplifier from its plastic bag. Before placing the unit in your home, read this carefully. CAUTION! Various regulation agencies require us to bring the following information to your attention. Please read carefully. WARNING To prevent fire or shock hazard, do not expose this unit to rain or moisture. -
Page 4: Installation
Installation The KT150 power tubes have been carefully matched at the factory and the tube bias has been set accordantly. To prevent the output tubes from damage and disconnecting, the power tubes are not installed during transport. The box of each KT150 tube is marked with the number corresponding to its correct location on the amplifiers main circuit board. - Page 5 Front Panel 1. Source Selector: Selects the appropriate If the Tape Monitor is accidentally left on, input signal source. none of the inputs on the Source Selector will operate. 2. Tape Monitor: If you have connected a tape recorder to the “tape in” on the back 3.
- Page 6 AC. POWER C O P L A N D SERIAL NUMBER: INTEGRATED AMPLIFIER MAX. POWER CONSUMPTION DESIGN BY COPLAND Model No. MADE IN DENMARK 50/60 Hz. VOLTAGE: Phono/RIAA Section: Accepts input from a Turntable. The amplifier is designed for a MM magnetic pickup (cartridge) or MC (Moving Coil).
-
Page 7: Maintenance
Maintenance The CTA408 is built for a long lifetime, and no special care needs to be taken, except from what is already described under installation. However, the heart of the amplifier is the tubes, and like a light bulb, they have a limited lifetime. After a period of time, they may affect the performance of the amplifier. -
Page 8: Specifications
Specifications Output power: 2x75W into 3,5 ohms or 8 ohms load. Nominal speaker impedance: 4 & 8 ohms Line input impedance: 50 K ohms Phono input impedance: 47 K ohms (MM) 50, 100, 470 Ohms (MC) Line Inputs sensitivity: 250 mV Phono sensitivity: 3.0 mV (MM) 0.26 mV (MC)
Need help?
Do you have a question about the CTA408 and is the answer not in the manual?
Questions and answers