Id Internal Tx Memory; Power Keyswitch - AUTEC AIR Series Original Instructions Manual

18
7.2

iD internal tx memory

The transmitting unit may require the "ID internal tx memory", where the radio remote control's
address is stored.The technical data sheet indicates if the "ID internal tx memory" is required.
7.3

Power keyswitch

The transmitting unit may have a power keyswitch. It can either be:
- mechanical key (see paragraph 7.3.1)
- Key ID 0-1 (see paragraph 7.3.2).
7.3.1 Mechanical key
The mechanical key makes it possible to power the transmitting unit. When the mechanical
key is required to be used in a transmitting unit, the radio remote control cannot work if it
is not inserted.
7.3.2 Key iD 0-1
The "Key ID 0-1" makes it possible to power the transmitting unit.
It stores the radio remote control's address. Therefore, the "Key ID 0-1" can only be used
in the transmitting unit belonging to its related radio remote control: when the transmitting
unit requires the "Key ID 0-1", the radio remote control cannot work if it is not inserted. The
technical data sheet indicates if the "Key ID 0-1" is required.
As the radio remote control address is stored in the "Key ID 0-1", use it with utmost care to
reduce risks that may result from incorrect handling.
7.3.3 power keyswitch insertion
Perform the following operations to insert the power keyswitch:
1. push the power keyswitch inside the corresponding housing
2. rotate the power keyswitch clockwise.
7.3.4 power keyswitch removal
Perform the following operations to remove the power keyswitch:
3. rotate the power keyswitch anticlockwise
4. pull the power keyswitch to remove it from the corresponding housing.
LILK1E00-01
Operation
AUTEC - Air series