General Operating Instructions; Starting Up The Radio Remote Control - AUTEC AIR Series Original Instructions Manual

General operating instructions

6 General operating instructions
6.1

starting up the radio remote control

Starting up the radio remote control consists in establishing a radio link between the transmitting
unit and the receiving unit.
As required by standards ieC 60204-1 and ieC 60204-32, non authorised
use of the machine must be prevented.
The power keyswitch and/or the PiN CODe used for start up, make the radio
remote control compliant with such requirement.
If the transmitting unit does not have a power keyswitch, the radio remote control start up is
protected by PIN CODE.
On the contrary, when the transmitting unit needs a power keyswitch, radio remote control
start up is protected by the power keyswitch itself. If the risk assessment requires further
protection of the radio remote control start up, the PIN CODE may be activated.
The PIN CODE consists of a sequence of commands to be carried out by activating the
corresponding actuators during start up. The radio remote control will start up only with the
correct sequence.
Commands activated while typing the PIN CODE are not sent to the machine.
The procedure to enable and modify a PIN CODE is provided in the document "Menu of
Transmitting Unit (MTU)"; you can also find this document in the dedicated section on Autec's
website.
6.1.1 Power keyswitch start up (no PiN CODe)
When the receiving unit is powered on, perform the following procedure:
1. Insert a charged battery in the transmitting unit (see paragraph 7.1.1)
2. insert the power keyswitch in the transmitting unit (see paragraph 7.3.3)
3. press the START pushbutton until the green LED blinks slowly.
AUTEC - Air series
13
LILK1E00-01