Venmar HRV CONSTRUCTO 2.0ES User's And Installer's Manual
  1. Manuals
  2. Brands
  3. Venmar Manuals
  4. Fan
  5. HRV CONSTRUCTO 2.0ES
  6. User's and installer's manual

Venmar HRV CONSTRUCTO 2.0ES User's And Installer's Manual

Hide thumbs Also See for HRV CONSTRUCTO 2.0ES:
Table of Contents

Advertisement

Quick Links

See also: User Manual , Installation Manual
VB0253
VB0254
USER AND INSTALLER MANUAL
R
EAD AND SAVE THESE INSTRUCTIONS
RESIDENTIAL USE ONLY
T
HESE
STAR
GUIDELINES SET BY
AND THE
REQUIREMENTS ONLY WHEN USED IN
HRV CONSTRUCTO 1.5ES
HRV CONSTRUCTO 2.0ES
HRV SOLO 1.5ES
HRV SOLO 2.0ES
HRV NOVOFIT 1.5ES
HRV NOVOFIT 2.0ES
100H
200H
NOVO+ 100H
NOVO+ 200H
PRODUCTS
EARNED
THE
®
BY MEETING STRICT ENERGY EFFICIENCY
N
R
ATURAL
ESOURCES
US EPA. T
ENERGY STAR
HEY MEET
46110
47110
46720
47720
46121
47121
1601706
1601708
1601717
1601719
ENERGY
C
ANADA
C
.
ANADA
20503
. 10
REV

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HRV CONSTRUCTO 2.0ES and is the answer not in the manual?

Questions and answers

Related Manuals for Venmar HRV CONSTRUCTO 2.0ES

Summary of Contents for Venmar HRV CONSTRUCTO 2.0ES

  • Page 1 USER AND INSTALLER MANUAL HRV CONSTRUCTO 1.5ES 46110 HRV CONSTRUCTO 2.0ES 47110 HRV SOLO 1.5ES 46720 HRV SOLO 2.0ES 47720 HRV NOVOFIT 1.5ES 46121 HRV NOVOFIT 2.0ES 47121 VB0253 100H 1601706 200H 1601708 NOVO+ 100H 1601717 NOVO+ 200H 1601719 VB0254...
  • Page 2 Please take note that this manual uses the following symbols to emphasize particular information: ⚠ WARNING Identifies an instruction which, if not followed, might cause serious personal injuries including possibility of death. CAUTION Denotes an instruction which, if not followed, may severely damage the unit and/or its components. NOTE: Indicates supplementary information needed to fully complete an instruction.

  • Page 3: Table Of Contents

    TABLE OF CONTENTS FOR THE USER ........4 7. CONTROLS ..........11 7.1 Setting Extended Defrost ........11 1. USING THIS UNIT ........4 7.2 Electrical Connection to Optional Wall Control ..12 1.1 Your ventilation system ...........4 7.2.1 Altitude or Platinum ..........13 1.2 Integrated Control...........4 7.2.2 Deco-Touch .............

  • Page 4: For The User

    For more information about their operation modes refer to the Main and auxiliary wall control User Guide, VD0278 included with the ventilation unit and also available at www.vanee.ca or www.venmar.ca.  Would you like to receive occasional informational e-mail off ers including Aimeriez-vous recevoir plus de détails sur nos promotions, off...

  • Page 5: User Servicing Instructions

    For the User 2. USER SERVICING INSTRUCTIONS 2.1 Q UARTERLY AINTENANCE ⚠ WARNING • Risk of electric shock. Before performing any maintenance or servicing, always disconnect the unit from its power source. • When cleaning the unit, it is recommended to wear safety glasses and gloves. Unplug unit.

  • Page 6: Warranty

    For the User 4. WARRANTY This ventilation unit is a high-quality product, built and packaged with care. The manufacturer warrants to the original purchaser of its product, that such products will be free from defects for the period stated below, from the date of original purchase. For all units, the warranty covers parts only against any operational defect.

  • Page 7: Air Distribution

    For the Installer CAUTION • Before installing this unit, please take the time to carefully read page 2 of this guide to ensure it is installed safely and properly. • For Novoclimat compliant installation requirements, please refer to the current Novoclimat Program criterias. 5.

  • Page 8: Installing The Ductwork And The Registers

    For the Installer 6.3 I NSTALLING THE UCTWORK AND THE REGISTERS ⚠ WARNING • Never install a stale air exhaust register in a closed room where a combustion device operates, such as a gas furnace, a gas water heater or a fireplace. •...

  • Page 9: Simplified Installation - Return/Supply

    For the Installer 6.3.4 S IMPLIFIED NSTALLATION ETURN UPPLY CAUTION 18” (0.5 When performing duct connections to the furnace supply MINIMUM duct, use metal ducts appropriately sized to support the additional airflow produced by the unit. Stale air exhaust ductwork: •...

  • Page 10: Connecting The Ducts To The Unit

    For the Installer 6.5 C ONNECTING THE DUCTS TO THE CAUTION • If ducts have to go through an unconditioned space (e.g.: attic), always use insulated ducts. • Make sure the vapor barrier on the insulated ducts does not tear during installation to avoid condensation within the ducts.

  • Page 11: Connecting The Drain

    For the Installer 6.6 C ONNECTING THE RAIN Cut 2 sections of plastic tubing of at least 12” each. Connect each one of them to the inner drain fittings located under the unit. Join their other ends to the "T" junction and remaining tubing as illustrated. This will prevent the unit from drawing unpleasant odors from the drain source.

  • Page 12: Electrical Connection To Optional Wall Control

    Use the chart below to verify compatibility with the optional controls before making any connection. Main Controls Auxiliary Controls • Deco-Touch • Dehumidistat HRV CONSTRUCTO 1.5ES • Lite-Touch Constructo • 20-minute lighted push button HRV CONSTRUCTO 2.0ES • Constructo • 60-minute crank timer • Altitude • Simple Touch Constructo • Dehumidistat HRV SOLO 1.5ES •...

  • Page 13: Altitude Or Platinum

    For the Installer 7.2.1 A 7.2.2 D LTITUDE OR LATINUM OUCH NO C NC I OC OL Y R G B NO C NC I OC OL Y R G B MODE SMART PREF VE0181 VE0250 7.2.3 L 7.2.4 C OUCH ONSTRUCTO IMPLE...

  • Page 14: Balancing The Unit

    For the Installer 9. BALANCING THE UNIT REPARATION Follow these steps to ensure accurate measurements: • Seal all the ductwork with tape. Close all windows and doors. • Turn off all exhaust devices such as range hood, dryer and bathroom fans. •...
  • Page 15 For the Installer Part Item Description Hinge assembly kit 13036 Damper supply port assembly 17245 Damper system actuator 17235 (incl. no. 4) Thermistor kit 17242 Capacitor 7.5 μF 17240 60809 Electronic board 60810 Transformer 17244 Double collar port 60818 60804 Blower assembly (incl.

  • Page 16: Wiring Diagram

    For the Installer 11. WIRING DIAGRAM ⚠ WARNING • Risk of electric shocks. Before performing any maintenance or servicing, always disconnect the unit from its power source. • This product is equipped with an overload protection (fuse). A blown fuse indicates an overload or a short-circuit situation. If the fuse blows, unplug the product and check the polarity and voltage output from the outlet.

  • Page 17: Troubleshooting

    For the Installer 12. TROUBLESHOOTING If the integrated LED of the unit is flashing, the unit sensors detected a problem. See the table below to know more about the nature of the problem. LED Signal Error Type Action LED flashes GREEN (double blink) Thermistor error Replace the thermistor kit.
  • Page 18 Service technicians only: If you require assistance or have questions after performing the following troubleshooting, call : HRV CONSTRUCTO 1.5ES HRV SOLO 1.5ES HRV NOVOFIT 1.5ES 1-800-649-0372 HRV CONSTRUCTO 2.0ES HRV SOLO 2.0ES HRV NOVOFIT 2.0ES 100H 200H NOVO+ 100H...

This manual is also suitable for:

Hrv solo 1.5esHrv constructo 1.5esHrv solo 2.0esHrv novofit 1.5esHrv novofit 2.0es200h ... Show all

Table of Contents

Save PDF