Slnet Numbering Plan - System Numbering - NEC SL2100 Quick Install Manual

Configure the SL2100
SLNet Numbering Plan – System Numbering
Use your SLNet Network plan to enter the remote extension numbering of all SLNet remote Nodes.
Remote extension numbers are set as Type: Networking System Access and the SLNet Networking Node ID
1~50 is entered.
Local extension numbers are set as Type: Extension Access. The Networking ID number is not required for local
numbers and should be set to 0.
Note – it is not possible to duplicate extension numbers at remote sites, each site must have a unique extension
number range.
Type of destination
Select Networking
System Access for
SLNet destinations
st nd
1 and 2
Total quantity
dialled digits
of dialled digits
Destination
Types in use
SLNet destination
node ID 1~50
Using the System Numbering to define the SLNet numbering plan will support the definition of the first two digits
st nd
(1 and 2 Dial Digits) to determine the remote extension numbers.
If you want to use a more detailed numbering plan then you must use F-Route Access.
The numbering plan must be setup at each system within the SLNet Network.
The example above would route:
200~209 are local extension numbers
210~229 to Node ID 3
3000~3999 to Node ID 2
500~599 to Node ID 2
Quick Install Guide – SL2100 SLNet rev1.0
24