Sharp CD G14000 Operation Manual page 31

Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning" on page 30.
2
Press the MEMORY button to enter the preset tuning
saving mode.
3
Within 30 seconds, press the PRESET (
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY button to store that
station in memory.
If the "MEMORY" and preset number indicators disappear
before the station is memorized, repeat the operation from step
2.
5
Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorized for that preset channel number will be erased.
Note:
The backup function protects the memorized stations for a few hours
should there be a power failure or the AC power cord become
disconnected.
To recall a memorized station
Press the PRESET (
select the desired station.
To scan the preset stations
The stations saved in memory can be scanned automatically.
(Preset memory scan)
1 Press the PRESET (
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET (
station is located.
or ) button to
To erase entire preset memory
1 Press the ON/STAND-BY button to enter the power stand-by
mode.
2 While pressing down the
the TUNER(BAND) button until "TUNER CL" appears.
or ) button for less than 0.5 seconds to
or ) button for more than 0.5 seconds.
or ) button again when the desired
5
4
3
2
1
REMOTE
SENSOR
TIMER
POWER
ON/ STAND-BY
c OPEN/
CLOSE
CD
5
TAPE
(1 2)
4
TUNER
(BAND) 3
PRESET PRESET
2
AUDIO IN
1
PRESET PRESET
TUNING TUNING
VOL. VOL.
button and the
TUNER
(BAND)
PRESET
CD-G14000
PRESET PRESET
button, press
31