Connecting The Ac Power Cord; Demo Mode - Sharp CD-BA120 Operation Manual

(Continued)
To AC INPUT
(Main unit operation)
2 "AA" size batteries (UM/SUM-3, R6, HP-7 or
similar)
Batteries are not included.

Connecting the AC power cord

Connect the AC power cord to the AC INPUT jack, then connect
the AC power cord plug to an AC outlet.
Notes:
To an AC outlet Unplug the AC power cord from the AC outlet if the unit will
not be in used for a prolonged period of time.
Never use a power cord other than the one supplied. Use of
a power cord other than the one supplied may cause an
electric shock or fire.
AC 120 V, 60 Hz

Demo mode

When the AC power cord is first connected, the unit will enter
the demonstration mode.
To cancel the demonstration mode:
When the unit is in the stand-by mode (demonstration mode),
press the EQUALIZER/X-BASS/DEMO button.
The demonstration mode will be canceled, the display will dis-
appear.
To return to the demonstration mode:
When the unit is in the stand-by mode, press the EQUALIZER/X-
BASS/DEMO button again.
Note:
When the power is on, the EQUALIZER/X-BASS/DEMO button
can be used to select the extra bass mode or any of the pre-
programmed equalizer modes.
Remote control
When inserting or removing the batteries, push them toward
the
Installing the batteries incorrectly may cause the unit to mal-
function.
Precautions for battery use:
Insert the batteries according to the direction indicated in the
battery compartment.
Replace all old batteries with new ones at the same time.
Do not mix old and new batteries.
Remove the batteries if they are weak or if the unit will not
be used for long periods of time. This will prevent potential
damage due to battery leakage.
Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Notes concerning use:
8" - 20'
Replace the batteries if the operating distance is reduced or if
(0.2 m - 6 m)
the operation becomes erratic.
Periodically clean the transmitter LED on the remote control
and the sensor on the main unit with a soft cloth.
Exposing the sensor on the main unit to strong light may in-
terfere with operation. Change the lighting or the direction of
the unit.
Keep the remote control away from moisture, excessive heat,
shock, and vibrations.
5
ë
battery terminals.