Sharp Insight Electric Rang Installation Manual page 7

FASTEN BRACKET (WALL OR FLOOR MOUNTING)
leveling leg
floor mount
Figure 14
FASTEN BRACKET (FLOOR MOUNTING ONLY)
leveling leg
floor mount
Figure 15
b
drIll pIlot holes and Fasten braCket
Drill a / -inch pilot hole where screws are to be located. If bracket
1
8
is to be mounted to the wall, drill pilot hole at an approximate 20
degree downward angle. If bracket is to be mounted to masonry or
ceramic floors, drill a / -inch pilot hole 1
5
32
screws provided may be used in wood or concrete material. Use a
/ -inch nut-driver or flat head screwdriver to secure the bracket
5
16
in place.
c
leVel and posItIon range
• Measure from the countertop to the floor height to determine
the height that the back of the range needs to be set at.
• Loosen legs and lock nuts to set level of the range. (Note that
the lock nuts are only on the rear feet). See Figure 16.
Range Leg
Figure 16
max 1 1 /4"
wall mount
wall plate
Anti-Tip bracket
more than
1 1 /4"
wall
Anti-Tip bracket
3 / inches deep. The
4-
Lock Nut
(Rear leg only)
InstallatIon Manual
• Adjust the back leveling legs with an adjustable wrench or pliers.
Measure from the floor to the bottom of the cooktop glass (X)
and adjust the legs to match the measurement (Y) taken from
the cutout. See Figure 17.
Figure 17
• After leveling, tighten the lock nuts on the rear to prevent the
feet from turning when sliding into position. See Figure 18.
Figure 18
A minimum clearance of 1 /8-inch is required between
note:
the bottom of the range and the leveling leg to allow room for the
bracket. Use a level to check your adjustments. Plug range into
properly prepared electrical receptacle or if hard wired, check that
it was completed properly. Check floor condition for evenness and
stability. Slide range back into position. See Figure 19.
1 5 /8" to edge
of bracket
Range Slide
Figure 19

(X")
(Y") floor to bottom
floor to top off cooktop
of countertop
glass