Table of Contents
Advertisement
6-1 Processing cable end
Applicable cable
High frequency coaxial cable: ME-5C-2V
Required tools
Stripper for high frequency coaxial cable: CST-TM
Processing procedure
Move the cam wheel of the stripper (amber colored
ring) back and forth and the cable holder moves back
and forth accordingly. Confirm this movement of the
stripper first.
To hold the stripper, put your forefinger through the
hole and move the cam while pushing back and forth
with your thumb.
6
Set the operation range of the cable holder by moving
the slider at the bottom of the body. Move to the left
to increase pressure.
In this example, set the slider to the cam wheel side's
end (right side) to set the pressure to low.
Adjust the cutting depth of the blade by turning the
two screws at both ends of the screw holder. Set
the blade position to within 1 mm from the cutting
surface of the blade cassette prior to adjusting the
cutting depth. For the cutting depth adjustment, use
the "blade setting gauge" supplied as an accessory
and match the blade position with the caved position
of the gauge. Then move the cam wheel forward
and secure firmly. Turn right lightly both adjustment
screws at either end of the screw holder for
adjustment. (Be careful not to break the blade setting
gauge as it is made of aluminum.)
To the next page
<Basic operation>
<Pressure setting>
<Adjustment of blade cutting depth>
(Fine adjustment is required to get the
optimum cutting depth.)
Blade cassette
Screw holder
6-2
Front
Cable holder
Cam wheel
Rear
Blade (slashed area)
Within 1 mm
Set the blade to within
1 mm in order not to
damage the blade by
the blade setting gauge.
Cam wheel
Left
Slider
Right
Blade setting gauge
Advertisement
Table of Contents
