Drive Axle Hanger Bracket And Hose Maintenance - TPC TIREBOSS Service Manual

TIREBOSS
TM
Tire Pressure Control
Drive Axle Hanger Brackets and Hose Maintenance
Typical Wheel Hanger Position & Hose Length for units NOT using tire chains.
Note position of hanger brackets. Units not using tire chains should have the hanger brackets adjusted to the lowest possible position without going
below the centre line of Rotary Unions
Typical Wheel Hanger Position and Hose Length for units using tire chains.
Note position of hanger brackets. Units using tire chains should have the hanger brackets adjusted to the highest possible position.
Ideal height and hose length
-
Top of hoses should drop just below bottom
line of Rotary Union
Hoses too long
-
May wrap around Rotary Union or kink
Hoses too short
-
May create excessive wear on Rotary
Unions as axles travels up and down
f:tec\manuals\Service\SERVICEv5.indd -
.
.
.
V6-0615
Ideal height and hose length
-
Top of hoses should drop just below bottom
line of Rotary Union
Hoses too long
-
May wrap around Rotary Union or kink
Hoses too short
-
May create excessive wear on Rotary Unions
as axles travels up and down
4-8
SERVICE MANUAL
.
.
.