Table of Contents
Advertisement
Available languages
Available languages
•Understanding Error Conditions:
The jump starter shall display an Error Condition when a
reverse polarity condition is present, a battery below two
(2) volts, or the internal battery overheating. When one
of these Error Conditions are present, the following will
happen:
Error
Error LED
Solid Red
Error LED
Blinking Red
w/Cables Connected
Properly
Boost Light Does
Not Come On
w/Cables Connected
Properly
•Charging the Jump Starter:
Connect the jump starter using the included USB charge
cable to the USB IN port. It can be recharged from any
USB powered port, like an AC adapter, car charger,
laptop and more. The USB IN port is rated at 2.1 Amps
to ensure safe and efficient charging of the internal lithium
battery. Due to FCC regulations, we recommend not to
charge and discharge the unit at the same time.
Reason/Solution
Reverse polarity/
Reverse the battery
connections.
The internal battery is too
hot/
Allow the unit to cool.
Bring the unit into cooler
environment.
Connected battery is below
2 V/
Remove all loads, and
try again, or use Manual
Override Mode.
19
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Eliminator 011-1906-4 and is the answer not in the manual?
Questions and answers
Why does the warning ⚠️ light flash on and off while I'm charging the jump starter battery
The warning light does not flash on and off while charging. Instead, the 100% Charge LED will ‘breathe’ on and off during charging and turn solid green when fully charged.
This answer is automatically generated
comment acheter un cable usb pour model 001-1906-4
To buy a USB cable for the MotoMaster model 011-1906-4, use the included cable or a compatible third-party cable. Ensure the third-party cable meets USB 2.0 standards. For safety, avoid low-quality cables, as they may cause electrical risks or damage the product.
This answer is automatically generated