Reference And Sequencing; Calibration; Cloning; Serial Comms - Parker 650 Safety Booklet & Quickstart

This manual was downloaded on www.sdsdrives.com
English

Reference and Sequencing


Speed potentiometer: 1 (Low), 4 (High),
2 (Wiper) OR

External speed reference: 1(-) and 2(+)

Start contact between 6 and 7

Jog contact between 6 and 9

Reverse Direction contact between 6 and 8

Calibration

All calibration is done in software, through the keypad.
SAVING
Changes
take effect
as soon as
they are
entered and
parameters
are saved
automatically
in a few
seconds

Cloning

The 650X drives may be cloned using the 6514 Clone
option that plugs into the keypad slot. Settings include
to/from, I/O configuration and full/part transfer.

Serial Comms

The 6513 Serial Communication option can be
plugged into the keypad slot. It can be used to exchange information between the Master and Slave drives in
RS485/232 format, up to 32 units can be connected together. Front panel LED indicators provide status and
health indication.
+44 (0)117 938 1800 - info@sdsdrives.com
650V & 650G only
Power-up
screen
SETUP PARAMETERS
P1 Application Select Select the application macro
P2 Max Speed
P3 Min Speed
P4 Acceleration time
P5 Deceleration time
P6 Motor Current
P7 Base Frequency
P8 Jog Setpoint
P9 Stop Mode
P11 V/Hz shape
P12 Overload Rating
P13 Fixed Boost
P99 Password
POWER ON
d1 Frequency
d2 Speed Setpoint
d3 DC Link Volts
d4 Motor Current
The drive powers up in
red buttons to start/stop and the up/down arrows to adjust
speed. To switch to
button down until
rdy
MODE: At the
Set max speed in Hz
Set min speed in %
Accel time to Max Speed in sec
Decel time from Max Speed in sec
Motor full load current in amps
Motor nameplate frequency in Hz
Set jog speed in % of max speed
0=Ramp; 1=Coast; 2=Injection braking
0=Linear; 1=Quadratic (fan or square)
0=150% for 30s.; 1=110% for 10s.
Set boost in % volts (V/Hz mode only)
Set from 0001 to FFFF for protection
If using three wire control

Start button (n.o.) between 6,7

Stop button (n.c.) between 6,10
650V & 650G only
DIAGNOSTICS
Output frequency (Hz)
Speed SP (% of Max Speed)
Voltage of DC Bus
Motor Current (amps)
LOCAL MODE.
REMOTE MODE,
L0C
disappears. To revert to
screen, push STOP until
1-4
Use the green/
hold the STOP
LOCAL
L0C
appears.