Siemens SIMATIC HMI series Operating Instructions Manual page 87

Ex approval
The following approvals apply to the device in accordance with
● IEC 60079-0:2011 and EN 60079-0:2012 +A11:2013
● IEC 60079-15:2010 and EN 60079-15:2010
● IEC 60079-31: 2013 and EN 60079-31:2014
valid:
Observe all information on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/291285) regarding use of the device in
hazardous areas.
When using the device in hazardous areas, ensure that all connectors connected to the
device are secured in a captive manner, see section "Securing cables for use in hazardous
areas (Page 70)".
You can find more information about explosion protection, EC conformity declarations and
other certificates on the Internet at the following addresses:
● IFP certificates (https://support.industry.siemens.com/cs/ww/en/ps/16788/cert)
● IFP PRO certificates (https://support.industry.siemens.com/cs/ww/en/ps/21662/cert)
The table below describes the test numbers of the HMI device classes:
Manufacturer site
Siemens AG
Division Digital Factory
Werner-von-Siemens-Straße 50
92209 Amberg
Germany
Siemens AG
Östliche Rheinbrückenstr. 50
76187 Karlsruhe
Germany
IFP, IFP PRO, IFP ETH
Operating Instructions, 11/2017, A5E31298376-AH
II 3 G Ex nA IIC T4 Gc
II 3 D Ex tc IIIC T 70 °C Dc
HMI device class
Comfort Panel, ITC, IFP
IFP1900/2200 ETH
Technical information
7.1 Certificates and approvals
Test number
DEKRA11ATEX0005X
IECEx DEK 13.0085X
DEKRA15ATEX0119X
IECEx DEK15.0080X
87