Advertisement
Quick Links
ModMic Wireless
Surface Choice
Find a flat spot on the headphones for the 0.5" circle of adhesive. The adhesive will stick to smooth and
mesh surfaces but does not stick well to rubberized surfaces.
1. Put the headphones on to ensure the ModMic will reach the corner of your mouth from the desired
mounting point.
2. Thoroughly clean and dry the surface with the included alcohol pad.
Attaching & Orientation
1. Connect a
to the ModMic base via the magnet.
2. Remove the protective backing from the adhesive.
3. While holding the ModMic, orient the mic boom
angle down so it points towards where your mouth
will be when using your headphones. This will reduce
the need for additional bends in the boom after
installation (see figure A).
4. Press the whole mic/clasp down onto the cleaned
spot and hold firmly for 60 seconds. On mesh or
curved surfaces, allow the adhesive to cure for 1
hour.
5. For best results the ModMic Wireless is designed to
be attached to the right side of your headphones so
the charging port is facing down (see figure B).
For more information/extra clasps/questions/feedback visit www.AntlionAudio.com Designed in Portland, Oregon.
Manufactured in China. ModMic and Antlion logo are trademarks of GTDevice LLC. U.S. and International patents
www.AntlionAudio.com
A
B
Facebook: AntlionAudio
Twitter: @AntlionAudio
Advertisement
Related Manuals for Antlion Audio ModMic Wireless
Summary of Contents for Antlion Audio ModMic Wireless
- Page 1 firmly for 60 seconds. On mesh or curved surfaces, allow the adhesive to cure for 1 hour. 5. For best results the ModMic Wireless is designed to be attached to the right side of your headphones so the charging port is facing down (see figure B).
- Page 2 1. Insert the USB charging cable into any USB 2.0 or higher port. 2. Plug the USB cable into the ModMic Wireless’ micro USB port. A yellow indicator light should be blinking slowly to indicate charging. A solid yellow light indicates full charge.
- Page 3 To which side of the headphones should I attach the ModMic Wireless? The ModMic Wireless can attach to either side of the headphones, however, we recommend attaching the ModMic to the right side of the headphones with the micro-USB port facing down to make it easier to charge while in use.
-
Page 4: Troubleshooting
Do you need a little more help? Here are some common troubleshooting steps that may help you out. 1. Ensure the ModMic Wireless mute is disabled. The red light should be off, if on, press the button once to disable mute. -
Page 5: Led Diagram
Button 1. Connect the USB Receiver either directly of via (Power/Mute) the USB extension cable (preferred). Red LED 2. Power on the the ModMic Wireless by briefly Yellow LED (Mute) (Charging/Battery) pressing the power button. 3. If paired, the blue light on both will be solid. - Page 6 ModMic Wireless Pursuant to FCC 15.21 of the FCC rules, changes not expressly approved by Antlion Audio might cause harmful interference and void the FCC authorization to operate this product. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
-
Page 7: Warranty
1. When charging, please put this product on a dried or ventilated area and keep it far away from heat sources or explosive products. 2. Do not charge the battery if ModMic Wireless is hot to the touch. Otherwise it may damage the battery and could be a fire hazard.
Need help?
Do you have a question about the ModMic Wireless and is the answer not in the manual?
Questions and answers