Craftsman 124.58833 Operator's Manual page 11

Figure 22
Figure 23
Replace
Rear Panel
RAIL BRACE INSTALLATION
Refer to Figure 24.
Tools Required: 13mm Open end Wrench
Hardware Required: Four M8 x 16 hex head bolts,
four 8mm lock washers, four 8mm flat washers and four M8
acorn nuts. (Hardware bag #2).
• Insert four M8 x 16 hex bolts through holes in bracket at
each end of brace.
• Attach brace to the far right end of the rails by sliding hex
bolts into the rail T-slots. Secure bolts in position with 8mm
flat washers, 8mm lock washers and 8mm acorn nuts.
Figure 24
Brace
8mm
Flat Washer
Rail
Joint
8mm
Acorn Nut
8mm
Lock Washer
ATTACH SWITCH ASSEMBLY
Refer to Figure 25.
Tools Required: 10mm Open end Wrench.
Hardware Required: Two M6 x 16 hex head bolts, two M6
flat washers, two M6 lock washers and two M6 hex nuts.
(Hardware bag #3).
• From the top of the switch bracket, insert two bolts
through bracket holes.
• Loosely attach flat washer, lock washer and nut to bolts.
• Insert bolt heads into T-slot on bottom of left front rail.
• Slide switch assembly 6" to 8" from left end of rail as
shown in Figure 25.
• Fully tighten flat washers, lock washers and hex nuts to
secure switch assembly in place.
6" to 8" from
Left End of Rail
Figure 25
RIVING KNIFE POSITION AND ADJUSTMENT
Refer to Figure 26.
• The riving knife is pre-installed on the saw. Raise the blade
completely to access the riving knife.
• Loosen the locking knob and raise the riving knife to its
highest position. Riving knife has three holes for three posi-
tions. The highest position is for all thru cuts. The middle
position is for rabbets and other non-thru cuts, (with guard
and pawls removed). The lowest position is for dado cuts.
Locking Knob
RIVING KNIFE POSITION AND ADJUSTMENTS
CONTINUED ON PAGE 12
11
Figure 26
Locking Pin
Socket Head
Cap Screw
Riving Knife
Bracket