Siemens Mobile 750 Operating Manual page 50

BIOS Setup
COM port - Serial port
This field switches the serial port on or off.
The serial port can be set to a certain address and interrupt in the Base I/O Address field.
Enabled
The serial port is automatically set to the next available combination (address,
Auto
interrupt).
The serial port is disabled.
Disabled
Base I/O Base Address - Address of the serial port
i
This field is only visible when the Com Port field is set to enabled.
This field selects the address and the interrupt used to access the relevant serial interface.
3F8h IRQ4, 2F8h IRQ3, 3E8h IRQ4, 2E8h IRQ3, 3F8h IRQ5, 2F8h IRQ7, 3E8h IRQ5, 2E8h IRQ7
The serial port is set to the shown address and interrupt.
IrDA port - Infrared interface
This field switches the infrared interface on or off.
If you wish to use infrared data transfer, an infrared interface with the associated hardware must be
incorporated in the device.
The infrared interface can be set to a certain address and interrupt in the Base I/O
Enabled
Address field.
The infrared interface is automatically set to the next available combination (address,
Auto
interrupt).
The infrared interface is disabled.
Disabled
Base I/O Address - Address of the infrared interface
i
This field is only visible when the IrDA Port field is set to Enabled.
This field selects the address and the interrupt used to access the relevant IrDA interface.
3F8h IRQ4, 2F8h IRQ3, 3E8h IRQ4, 2E8h IRQ3, 3F8h IRQ5, 2F8h IRQ7, 3E8h IRQ5, 2E8h IRQ7
The IrDA interface is set to the shown address and interrupt.
50
Advanced menu - Advanced system settings
A26391-K84-Z100-1-7619