Troubleshooting - DeWalt DXAEPS2 Instruction Manual

Troubleshooting

Problem
Unit will not charge
Unit fails to jump-start
DXAEPS2_ManualENSP_101216.indd 24
Possible Solution
Make sure all of the unit's functions are
turned off.
Make sure a suitable gage extension
cord is properly connected to both the
unit and a functioning AC outlet.
or
Make sure the 12 volt DC charger is
properly connected to both the unit and
a functioning DC power source.
Check the connection to the AC or DC
power source.
Confirm there is a functioning AC or
DC current.
Check that the fuse in the 12 Volt DC
Adapter is not blown.
Make sure unit's Jump Starter Power
Switch is in the on position.
Make sure a proper polarity cable
connection has been established.
Make sure the Clamp Connector is
securely connected to the Clamp
Connection Slot.
Problem
Unit fails to jump-start
(continued)
Portable Compressor
will not inflate
24
Possible Solution
Make sure the unit is not being operated
in the Compressor mode.
Check that the unit has a full charge.
Recharge the unit if necessary.
Make sure the Compressor Power
Button has been pressed to turn the
compressor on.
Make sure the unit is not being
operated in the Jump Starter mode.
Make sure the SureFit nozzle is
®
securely screwed on to the valve stem
when attempting to inflate tires; or that
the nozzle adapter is securely screwed
into the SureFit nozzle and is inserted
®
properly into the item to be inflated on
all other inflatables.
Check that the unit has a full charge.
Recharge the unit if necessary.
10/19/2016 3:56:35 PM