Portable Compressor - DeWalt DXAEPS2 Instruction Manual

2. If the unit detects that the alternator is good, the backlit LCD screen
will display the following:
The Battery Status Icon, Alternator Icon, and "ALT GOOD" will light
solid.
3. If the unit detects that the alternator is out of typical voltage range,
the backlit LCD screen will display the following:
The Battery Status Icon, Alternator Icon and "ALT" will light solid.
The Fault Icon will flash.
4. Press the Alternator Check Button again to stop the test and turn
off the unit.
IMPORTANT: Always turn the unit off when not in use. Recharge this
unit fully after each use.

Portable Compressor

The built-in 12 volt DC compressor is the ultimate compressor for all
vehicle tires, trailer tires and recreational inflatables. A nozzle adaptor is
supplied that screws onto the end of the SureFit
of the compressor hose. The compressor hose with tire fitting is stored
DXAEPS2_ManualENSP_101216.indd 18
in the compressor hose storage compartment. Refer to the "Features"
illustration for locations of compressor hose. The Compressor Power
Button and Increase ( ) and Decrease ( ) Compressor Pressure
Control Buttons are located on the control panel on the front of the unit.
Before proceeding, check the unit's battery status on the LCD screen.
Four solid bars in the battery icon indicates a full battery. When the
battery level is nearly empty with only one solid bar, the unit MUST be
recharged before use or the unit's built-in low voltage protection will
activate. The empty Battery Status Icon will flash for a short period of
time before automatic shut down.
The compressor is capable of inflating up to 120 pounds per square
inch (psi) pressure. The compressor can operate long enough to fill up
to 3 average sized tires before the battery must be recharged. Return
hose to the storage compartment after use.
IMPORTANT: Make sure the Jump Starter Power Button has been
turned off before attempting to use the unit as a Compressor.
WARNING – To reduce the risk of serious injury or property damage:
Follow all safety instructions found in the "Specific Safety Instructions
for Compressors" section of this instruction manual.
CAUTION – To reduce the risk of serious injury or property damage:
When the compressor is operated at a low PSI, the unit may start in
low and gradually rev up. When the compressor is operated at higher
PSIs, the unit may operate normally for several minutes, then rev down
for a few minutes before returning to normal operation. This feature
protects the unit from overheating during normal use. In any event, do
not operate compressor continuously for longer than 10 minutes, as
it may overheat. This could damage the compressor. If the compressor
must be operated for longer periods: every 10 minutes press the
Compressor Power Button to turn the compressor off, then restart
after a cooling down period of approximately 30 minutes.
nozzle at the free end
®
18
10/19/2016 3:56:34 PM