TDK A360 User Manual

Wireless 360
Speaker
AC CONNECTION/RECHARGING THE BATTERY
1. Select the appropriate
plug for your country
and connect it to the AC
power adapter.
2. Connect the AC power adapter jack to the DC IN jack on the rear of the unit and then connect
X
the plug to a 100V-240V wall outlet.
This unit has a built-in rechargeable battery that will automatically be charged as long as the unit is
plugged in. If the battery is low, the Battery indicator will turn on. The Battery indicator will blink red
v
when low. It will be solid red when charging.
Note: The battery will provide approximately 6 hours of operation at normal listening level.
Notes:
• Only use the supplied AC adapter.
• Remove both the DC plug and AC-IN plug to disconnect AC adapter when not in use.
• Disconnect the AC cord to use with DC power (rechargeable battery).
Replacing the Rechargeable Battery:
If the battery does not supply enough power (see Rechargeable Battery Notes below), order a replacement
battery at www.tdkperformance.com and remove the four screws on the left side of the unit. Disconnect
the connector and remove the battery. Then connect the new battery and reinsert the four screws.
Rechargeable Battery Notes:
• Each time you charge and discharge the battery (charge cycles), battery capacity slightly diminishes.
Rechargeable batteries have a limited number of charge cycles and need to be replaced eventually.
• You may wish to replace your battery when, or before, the battery does not supply enough power
to function your device. Also, proper disposal is essential from environmental and safety point of
view. Putting any battery directly in the trash will harm the environment.
• Do not incinerate.
LOCATION OF CONTROLS
1
2
8
9
10
1. Power/Volume Control 8. USB Charge Jack
2. Low Battery Indicator 9. DC IN Jack
3. Carrying Handle 10. Rubber Flap
4. Bluetooth ® and Aux Source Indicators 11. AUX Jack
5. Treble/Bass Button 12. Battery OFF/ON Switch
6. Treble/Bass Indicators
7. Source/Select Button
OPERATION
Turning the A360 On and Off:
1. For AC operation: Press the Power/Volume control on the main unit to turn the power on.
u
2. For DC operation: Slide the Battery switch to the ON position. Press the Power/Volume control
al
u; the unit will turn on the previous source and volume.
3. To turn the power off, press the Power/Volume control u.
Pairing a Bluetooth Device
1. Turn the A360 on; the LED(s) around the Power/Volume control will light and the previously
listened to source and volume will be selected.
2. Press and hold the Source/Select button until the Bluetooth indicator blinks rapidly to make the
V
A360 "discoverable."
3. On the Bluetooth device, enable Bluetooth and select "A360" from the Device List. If the Bluetooth
device asks for a passkey, use "0000". Some Bluetooth devices will ask you to accept the
connection. If the units are paired properly, the speaker will beep and the Bluetooth indicator will
light solid blue. If it failed, the Bluetooth indicator will blink slowly.
IMPORTANT: After step 3, you have two minutes to pair the units.
Note: After you pair a device, the A360 will remember it for future use.
Using a Bluetooth Device
1. Turn the A360 on; the LED(s) around the Power/Volume control will light and the previously
listened to source and volume will be selected
2. With a unit paired (see previous section), press the Source/Select button
indicator lights.
3. Operate your Bluetooth device and its sound will be heard through the A360's speakers.
4. Adjust the volume by rotating the Power/Volume control
the Bluetooth device, and adjust the Bass and Treble as described later in this guide.
AUX Jack (Rear of A360)
1. Insert one end of an audio cable (not included) into
the LINE OUT or Headphone jack on your external
audio unit and the other end into the AUX jack on
ak
the rear of the A360, under the flap.
2. To listen to the external audio unit, turn the A360 on
and press the Source/Select button once so the
V
AUX indicator lights to select the Line In mode.
3. Start playback of the external unit and the external
audio unit's output sound will be heard through the
A360's speakers.
4. Adjust the volume using the Power/Volume control
u
on the A360, or the Volume control on the Bluetooth
3
device, and adjust the Bass and Treble as described later in this guide.
Charging a USB Device with the A360's USB Jack
Connect your device via USB to the USB jack on the A360. Your device will charge when the A360
W
is connected to AC power. Your device will also charge during operation in DC mode if Battery OFF/ON
switch is ON. The USB jack is only used for charging.
al
Note: USB charging will significantly reduce battery life in DC mode.
Setting the Treble and Bass
4
1. TREBLE: Press the Treble/Bass button until the Treble Indicator lights. Adjust the setting using the
y
5
Power/Volume control u.
6
2. BASS: Press the Treble/Bass button until the Bass Indicator lights. Adjust the setting using the
y
Power/Volume control u.
7
Note: After five seconds, the unit will save the Bass/Treble settings and revert to Volume selection mode.
Auto Power Off
If the unit has no audio signal or a USB device is not charging, for 20 minutes, the unit will turn itself
off. To "wake" the unit up, simply press the Power/Volume control u.
Splash Resistant
The A360 is splash resistant, but cannot be submerged in water or be subject to constant flow of water.
In order to ensure the product is splash resistant, close the rubber flap on the rear of the A360. To
properly close flap, fully insert center rubber dongle (on inside of flap at) into the DC IN jack
flap center is flush. Insert the other dongle into USB jack W, then smooth out entire flap until flap is
flush with the sides of the A360.
Troubleshooting
If the A360 is not producing sound, adjust the volume level on your digital music device to high.
SPECIFICATIONS AND COMPATIBILITY
11 GENERAL: Speaker Power Output .......... 2 W x 4 + 15 W (subwoofer)
Power Source (AC) ............. Input: 100-240V AC, 50/60Hz, Wireless Audio .............................. Bluetooth version 2.1,
12
........................................ 1.2 A max, Output: 19 V DC, 2A .................................................. A2DP profile, AAC Codec
Dimensions ........................... 6 (W) x 6 (H) x 6 (D) inches Line-input Audio .........................3.5 mm stereo jack up to
................................... 15.2 (W) x 15.2 (H) x 15.2 (D) cm ....................................................... 2.5 Vrms input signal
Weight ...................................................... 4.4 lbs / 2.0 kg USB Port. ................................. 5.0 V @ 0.5 A charge only
Speakers ............................... 4 x 1 inch full-range drivers,
..............................................................4 inch subwoofer
Specifications are subject to change without notice.
The TDK Life on Record Logo is a trademark of TDK Corporation and is used under license.
All other trademarks and logos are property of their respective owners.
The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Imation Corp is under license.
User Guide
Please read these instructions completely
before operating this product
TDKperformance.com
A360
FCC NOTE： This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
THE MANUFACTURER IS NOT RESPONSIBLE FOR
ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS OR CHANGE TO
THIS EQUIPMENT. SUCH MODIFICATIONS OR
CHANGE COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
so the Bluetooth
V
on the A360, or the Volume control on
u
until
X
36953002A
Wireless 360
Speaker
Guide d'utilisation
Veuillez lire l'ensemble des instructions
ci-dessous avant d'utiliser ce produit.
TDKperformance.com
A360