Controller Fault Descriptions And Corrective Actions; Controller Fault Groups - GE PACSystems RX7i Cpu Programmer's Reference Manual

9.4 Controller Fault Descriptions and Corrective Actions

Each fault explanation contains a fault description and instructions to correct the fault. Many fault
descriptions have multiple causes. In these cases, the error code and additional fault information are
used to distinguish among fault conditions sharing the same fault description.
9.4.1

Controller Fault Groups

Group Name
1 Loss of or Missing Rack
4 Loss of or Missing Option Module
5 Addition of, or Extra Rack
8 Reset of, Addition of, or Extra Option Module
11 System Configuration Mismatch
12 System Bus Error
13 CPU Hardware Failure
14 Module Hardware Failure
16 Option Module Software Failure
17 Program or Block Checksum Failure Group
18 Battery Status Group
19 Constant Sweep Time Exceeded
20 System Fault Table Full
21 I/O Fault Table Full
22 User Application Fault
24 CPU Over Temperature
128 System Bus Failure
129 No User Program on Power-up
130 Corrupted User Program on Power-up
131 Window Completion Failure
132 Password Access Failure
134 Null System Configuration for RUN Mode
135 CPU System Software Failure
137 Communications Failure During Store
140 Non-critical CPU Software Event
16 The fault action indicated is not applicable if the fault is displayed as informational. Faults displayed as informational,
always behave as informational.
If a system configuration mismatch occurs when the CPU is in RUN Mode, the fault action will be Diagnostic regardless of
17
the fault configuration. For additional information, refer to Fault Parameters in PACSystems RX7i, RX3i and RSTi-EP CPU
Reference Manual, GFK-2222.
GFK-2950C
Default Fault Action
Diagnostic
Diagnostic
N/A
N/A
Fatal
Fatal
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Diagnostic
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
February 2018
Chapter 9. Diagnostics
16 Configurable
Yes
Yes
No
No
17 Yes
Yes
No
No
No
No
No
No
No
No
No
Yes
No
No
No
No
No
No
No
No
No
397