Advertisement
Quick Links
Salvajor Commercial Disposers
For All Models: 75, 100, 150, 200, 300, 500, 750
2
Typical Installations
3
Installation of Cone Bowl or Sink Collar
4
Attaching Disposer to Cone Bowl or Sink Collar
5
Plumbing
6
Electrical
7
Operating Instructions
8
Warning and Safety Instructions
ALL INSTALLATIONS SHOULD BE MADE IN ACCORDANCE WITH
LOCAL AND NATIONAL PLUMBING AND ELECTRICAL CODES.
FOR PRODUCT/WARRANTY REGISTRATION
• Go to www.salvajor.com
• Click on SUPPORT at the top of homepage
• Click on PRODUCT REGISTRATION
The Salvajor Company
www.salvajor.com
Manufacturers of Commercial Food Waste Disposing Systems since 1944
4530 East 75th Terrace Kansas City, Missouri 64132-2081, USA
1 - 888 - SALVAJOR
Email: sales@salvajor.com
FAX : 1 - 800 - 832 - 9373
service@salvajor.com
Advertisement
Related Manuals for Salvajor 75
Summary of Contents for Salvajor 75
- Page 1 Salvajor Commercial Disposers For All Models: 75, 100, 150, 200, 300, 500, 750 Typical Installations Installation of Cone Bowl or Sink Collar Attaching Disposer to Cone Bowl or Sink Collar Plumbing Electrical Operating Instructions Warning and Safety Instructions ALL INSTALLATIONS SHOULD BE MADE IN ACCORDANCE WITH LOCAL AND NATIONAL PLUMBING AND ELECTRICAL CODES.
- Page 2 Models 300 through ( PP ) 750 furnished with single support leg. OPTIONAL REMOTE START/STOP 2" DRAIN (models 75-200) CONTROL 2" OR 3" DRAIN (models 300-750) WITH ( P ) OR ( PP ) " VALVE INCOMING WATER ( NF ) "...
- Page 3 Installation of CONE BOWL or SINK COLLAR CONE ASSEMBLY ⁄ " Sink Collar #70 1. Cut a hole in the counter top of the 1. Apply caulking compound around the sink appropriate table cutout dimensions hole (TOP SIDE). listed below. 2.
- Page 4 8. Extend the leg extension securely on the floor, and tighten set screws. NOTE: It is important that the leg fit tightly between the disposer and the floor. STOP! If you have any questions about this installation call 1 - 888 - SALVAJOR for installation advice.
- Page 5 7. Plumb 3/4" IPS line and reduce to 1/2" at A 2" adapter is supplied for existing 2" drains. the hand valve. Install the factory-supplied Models 75 thru 200 require a 2” drain. solenoid valve with built-in flow control. IMPORTANT! 8.
- Page 6 Salvajor disposer cutting elements are designed to operate in 3. Check the mounting assembly and plumbing connections either direction.
-
Page 7: Troubleshooting
Never strike the reset button with an object. 5. If the disposer remains inoperative after following these steps, contact the nearest Salvajor Factory Authorized Service Center, or the factory direct. You may obtain the telephone number of the Service Center nearest you by calling 1-888-SALVAJOR. -
Page 8: Safety Instructions
Push STOP button on control panel and shut off electrical power to the panel before attempting to clear a jam. When attempting to clear a jam in a disposer use a Salvajor dejamming tool or a long wooden object to reverse rotation...
Need help?
Do you have a question about the 75 and is the answer not in the manual?
Questions and answers