Sanyo POA-HDTM01 Owner's Manual page 13

Rear
q
r
q INPUT 1 COMPONENT
Connect component output signal
(Y-Pb/Cb-Pr/Cr) from video equip-
ment to this terminal.
w INPUT 2 DIGITAL (DVI-D)
Connect DVI digital output signal
from computer to this terminal.
e INPUT 3 HDMI
Connect HDMI output signal from
video equipment to this terminal.
This input is only available in the
single mode.
✐ - This input cannot be selected in the
broadcast mode.
- When selecting this input in the single
mode, the "Broadcast Mode" cannot
be selected in "Mode Select".
w
Note:
When you want to use the transmitter in the upright position, you
can use the supplied 2 stands. The antenna is provided near the
ventilation slot, so it is recommended to stand the transmitter as
shown in the figure for keeping the wireless communication in
good condition.
e
t
r DC 16V
Connect the AC adapter (supplied).
t SERIAL
- This terminal is used to service the
transmitter.
- If you control the transmitter by
computer, you must connect a se-
rial cross cable (not supplied) from
your computer to this terminal.
y VENTILATION SLOT
Do not cover the ventilation slot
during operation.
HD DATA WIRELESS TRANSMITTER BOX
Preparation
y
1
OWNER'S MANUAL