NEC Express5800 Series User Manual page 62

Chapter 2 Preparations
Install a 3.5-inch fixed HDD cage and hard disk drives in the server by using the following procedure.
1. See steps 1 to 3 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2. To remove the side cover and front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
3. Insert the HDD cage into the HDD bay. The
"TOP" must face rightward.
4. Attach the HDD cage by using the four
screws.
5. Place the unit so that the flat face of the hard disk
drive faces downward. Mount the HDD trays that
come with the HDD cage from both sides of the
3.5-inch hard disk drive. Mount the tray marked
"A" on the left side, and the tray marked "B" on
the right side.
6. Insert the hard disk drive attached to the tray with
HDD tray "A" facing the right side into the slot of
the HDD cage until it clicks, indicating that it is
locked.
7. Connect the interface cables and power cable to the hard disk drive. Use the interface cables that
come with the HDD cage. For details about cable connection, see 1.15 Connecting Cables.
62
A
Express5800/T110i User's Guide
1. Installing Internal Optional Devices
The "TOP"
must face
rightward.
B