Sanyo PLV-75/PLV-80 Owner's Manual page 39

Logo
Logo settings can be altered as follows:
Logo select
This function decides what to be displayed on the starting-up dis-
play as follows:
Off . . . . . . .count-down only
Default . . . .the factory-set logo
User . . . . . .the image you captured
Capture
This function enables you to capture the image being projected
and use it for a starting-up display or interval of presentations.
After capturing the projected image, go to the Logo function and
set it to "User". Then the captured image can be displayed when
turning on the projector next time.
To capture the image, select [Yes]. To cancel the Capture
function, select [No].
NOTE;
• Before capturing an image, select Standard in the Image Select Menu
to capture a proper image. (See page 29, 33.)
• A signal from a computer can be captured up to XGA (1024 X 768).
• Certain signals may not be captured properly.
• When capturing the image that has been adjusted by the Keystone
function, the adjustment data is automatically reset and the projector
captures an image without keystone correction.
• When starting to capture a new image, the previously stored image is
cleared even if you cancel the capturing.
• Once you exit the Logo menu after setting Logo lock to "On", you are
required to enter the PIN code every attempting to change the Logo
setting.
Logo PIN Code Lock
This function prevents an unauthorized person from changing the
Logo setting.
Off . . . . .the Logo setting can be changed freely from the
Logo menu.
On . . . . .the Logo setting cannot be changed without the
Logo PIN code.
If you want to change the Logo PIN Code Lock setting, enter a
Logo PIN code along the following steps. The initial Logo PIN code
is set "4321" at the factory.
Enter a Logo PIN code
Select a number by pressing the POINT LEFT/RIGHT buttons and
fix the number with the SELECT button. The number will change
to "✳". If you fixed a wrong number, move the pointer to "Set" or
"Clear" once by pressing the POINT DOWN button, then return to
"Logo PIN code". Enter the correct number again.
Repeat this step to complete entering a four-digit number.
When the four-digit number is fixed, the pointer will automatically
move to "Set". Press the SELECT button so that you can change
the Logo PIN code lock setting.
If you entered a wrong Logo PIN code, "Logo PIN code" and the
number (✳✳✳✳) will turn red and disappear. Enter a correct Logo
PIN code all over again.
Logo
Select [Yes] to capture
the projected image.
Select [Yes] to
stop capturing.
Logo PIN Code Lock Dialog Box
Quit
After a correct Logo PIN code is entered, the
following dialog box will appear.
Select On/Off by pressing the POINT LEFT/RIGHT
buttons or change the Logo PIN code.
Change the Logo PIN code
Logo PIN code can be changed to your desired four-
digit number. Select "Logo PIN code change" with
the POINT DOWN button and press the SELECT
button. Set a new Logo PIN code.
Be sure to note the new Logo PIN code and keep it
at hand. If you lost the number, you could no longer
change the Logo PIN code setting. For details on
PIN code setting, refer to relevant instructions of the
PIN Code Lock function on page 42.
SETTING
Pointer
39