Service Request - Boge base control Operating Instructions Manual

base control

Service request

General
Automatic monitoring of
the control systems
Page 20
1.5
The main display shows a blinking spanner.
– all other functions remain unchanged.
If the Info key is pressed, the display only shows the blinking service
request number and the spanner.
Press Enter key
message key table) one of the three servicing interval back-counters must
be reset to its start value as under the respective service interval setting or
receiver inspection load cycle setting, and changed or confirmed by press-
ing Enter key .
Pre-acknowledgement
If a service message is acknowledged, the cause of which has not (yet) been
attended to, the spanner symbol continues to appear (but no longer blinking).
1.5 Faults
The tables on the following pages give information on the possible causes of
operating faults and measures for their rectification.
Caution!
Ensure that any work required to rectify faults is only carried out by trained
personnel or specialists. Ensure that components which have a safety func-
tion are only set, repaired or exchanged by BOGE Service!
Please contact the Technical Support at the following telephone numbers, if
you have any questions.
Telephone: +1-770-874-1570
Telephone: +49 5206 601-140
All data is stored in a memory module (EEPROM).
If a fault occurs while the data stored in the EEPROM is being read, the control
system will react as follows:
– The compressor is switched off.
– The following fault message appears in the display.
Faults
to acknowledge the request. If necessary (see also
BOGE base control for screw compressors