Install The Vxi-Mxi-2/B - National Instruments MXI-2 Reference Manual

a. Single VXI-MXI-2/B in Mainframe (Default)
c. VXI-MXI-2/B Between Two Others

Install the VXI-MXI-2/B

Note If you install the VXI-MXI-2/B in a VME chassis, ensure that no other devices drive
the VMEbus user-defined pins—rows A and C of P2/J2.
To protect both yourself and the chassis from electrical hazards, leave the chassis
Caution
power off until you finish installing the VXI-MXI-2/B module.
© National Instruments Corporation
W2
A5
C5
C30
NC
W2
A5
C5
C30
NC
Figure 6-11. VXIbus Local Bus Configuration
This section contains general installation instructions for the
VXI-MXI-2/B. Consult the user manual or technical reference manual
of your VXIbus chassis for specific instructions and warnings.
1. Plug in your chassis before installing the VXI-MXI-2/B. The power
cord grounds the chassis and protects it from electrical damage while
you install the module.
2. Remove or open any doors or covers blocking access to the chassis
slots.
Chapter 6 VXI-MXI-2/B Configuration and Installation
A5
C5
C30
NC
b. Leftmost VXI-MXI-2/B in Mainframe
A5
C5
C30
NC
d. Rightmost VXI-MXI-2/B in Mainframe
6-15
W2
W2
MXI-2 Configuration Reference Manual