Settings Before Using The Network Communication - Sanyo POA-PN03C Owner's Manual

Chapter 5 Network Capture

Settings before using the Network Communication

To use the Network Communication, the capture setting of the network should be set
either [1] or [2] described below.
[1] Setting the network unit searches all the available target computers in the net-
work automatically.
or
[2] Setting the target computers are registered to the network unit.
Perform capture setting following to the description below.
[1] When serving the capture data to all the tar-
get computers in the network.
By using the web browser, display "Communication set-
ting" from menu "Network"-"Capture"-"Page 2". Confirm
that the item Auto search target PC is "ON". If "OFF",
change mode to "ON".
* Network unit can find up to 30 computers in the network.
[2] When serving the capture data to the specific
target computers in the network.
Set item Auto search target PC is "OFF" described in
the above and then display "Connection setting" from
menu "Network"-"Capture"-"Page 3" with the web
browser. Enter the IP address of target computer and
click Set button to register.
* Up to 30 computers can be registered to the network unit.
To display the served capture data, the computer needs to operate the software Network Capture 3.
✐
7