THORENS TD160 Fitting Instructions Manual

Fitting the wand tonearm

Hide thumbs Also See for TD160:

Fitting The Wand Tonearm® to a Thorens TD160 family turntable

You should be able to use the Thorens arm lifter with The Wand Tonearm

A; Remove the existing arm

Step 1; Remove the platter, headshell and

Lifter bar (arrowed) Disconnect from power!

Step 3; Remove the arm cable clamp and

the white cable cover.

Step 5; Remove the cable base (Two screws)

Step 7;

Turn over and remove the arm.

(Three screws)

To be read in conjunction with The Wand User Guide.

Step 2; Support the turntable upside down

and remove the bottom cover. 4 screws.

Step 4; Unhook the lift mechanism

Step 6; Remove the armrest (two screws)

Hint; Improve your Thorens by adding

damping material to the underside of the

sheetmetal panels and the bottom cover while it is

off. (but watch adding too much weight to the

floating chassis part)

www.thewandtonearm.com

(TD150/166 similar)

Table of Contents

Need help?

Do you have a question about the TD160 and is the answer not in the manual?

Page 1 Fitting The Wand Tonearm® to a Thorens TD160 family turntable (TD150/166 similar) You should be able to use the Thorens arm lifter with The Wand Tonearm To be read in conjunction with The Wand User Guide. A; Remove the existing arm Step 1;...
Page 2 Step 4; Add earth wire to amplifier. (as below) or 3 core mains cable. Step 5; Add the Thorens lifter to the underside (if you are using it) Use 2x self-tapping screws. See previous page for correct orientation. Re-connect the lifter cable.
Page 3 Fitting The Wand Tonearm® to a Thorens TD160 family turntable (TD150/165 similar) C; Fitting The Wand Tonearm Mount Step 1; Install the spindle into mounting plate. Set the spindle height using the protractor. Lock in position using the nut (Classic) or grub screw (Plus).

Td150Td166