Radio Operation - Sanyo FXCD-550 Operating Instructions Manual

RADIO OPERATION

2
SELECTING RADIO MODE
Press the BND button to switch from CD player or tape mode to the radio.
Each time the BND button is pressed, the selected band changes as shown below.
FMI
........................................................ 2
RADIO TUNING
• Automatic tuning ............ Press the FF + or - REW button
the beep tones are on. When the button is released, the system will start
automatic tuning and stop at the next receivable station.
• Manual tuning ................ To select higher frequency stations, press the FF + button for less than 0.5
seconds.To select lower frequency stations, press the - REW button for less than
0.5 seconds. To quickly scan up or down in frequency, press and hold the FF +
or - REW button. Release the button when the display approaches the desired
frequency, then press and release the button repeatedly until the desired
frequency is displayed.
STORING PRESET STATIONS
The preset buttons can be used to store 6 stations in each band (FMI, FMII and AM) for convenient
access to your favorite stations.
• Programming stations.....
• Quick tuning.................... Select the desired band, then press one of the six preset buttons.
4
........................................ 1
FMII AM
................................... 3
Select the desired band, then tune in the station you want to store in memory.
1
Press and hold one of the preset buttons for more than 2 seconds.
2
Repeat steps 1 and 2
-9-
1
3
for more than 0.5 second until it beeps twice if
to program additional stations.