Sanyo ECD-T1535 Owner's Manual page 7

The adjustment mode will change in the following order:
By pressing VOL button + (11) or VOL button – (12), it is possible to adjust the
desired sound level.
• LOUDNESS
Press BND/LOU button (13) for several seconds to reinforce the bass output and
display will show "LOUD". Press it for several seconds again to release this function.
• SET THE CLOCK
Press the DSP button (15), the clock is shown on the LCD display. Then hold down
the button until the clock flashes. Then press the MANU/SKIP
change hours or MANU/SKIP button
• SELECT MODE
Press MOD button (6) shortly to choose desired listening mode.
[e.g. radio mode to CD mode to AUX mode]
• MUTE
Press MUT button (3) to mute the sound instantly. If any button is pressed in the
mute state, the mute mode is released.
• LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated functions on the display (8).
• EQUALIZATION
Press EQ button (19) to turn on equalization function and to select desired audio
mode. There are five kinds of mode as below:
FLAT
• AUXILIARY INPUT
The unit can be connected to a portable audio player through the AUX IN jack (24).
To hear the input signal, press MOD (6) button several times until the display shows
"AUX".
• FLASHING LED
If the front panel is not installed in the main unit, the LED (25) will be flashing.
• RESET
RESET button (26) can be activated with either a ball point pen or thin metal
object. RESET button (26) is to be activated for the following reasons:
- Initial installation of the unit when all wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Volume Bass
CLASSICS
Treble Balance
(16) to change minutes.
POP M ROCK M
7
Fader
button (17) to
DSP OFF