Troubleshooting - Sanyo ECD-T1535 Owner's Manual

TROUBLE SHOOTING
Before going through the check list, check wiring connection. If any of the problems
persist after check list has been made, consult your nearest service dealer.
Symptom
No power.
Disc cannot be
loaded or ejected.
No sound.
Sound skips.
The operation keys The built-in microcomputer
do not work.
The radio does not The antenna cable is not
work. The radio
station automatic
selection does not
work.
Cause
The car ignition switch is
not on.
The fuse is blown.
Presence of CD disc inside
the player.
Disc is upside-down.
Compact disc is extremely
dirty or defective disc.
Temperature inside the car
is too high.
Condensation.
Volume is in minimum.
Wiring is not properly
connected.
The installation angle is
more than 30 degrees.
The disc is extremely dirty
or defective disc.
is not operating properly
due to noise.
connected.
The signals are too weak.
If the power supply is properly
connected to the car accessory
circuits, but the engine is not
running, switch the ignition key
to "ACC".
Replace the fuse.
Remove the disc in the player,
then put a new one.
Insert the compact disc with
the label facing upward.
Clean the disc or try to play a
new one.
Cool off or until the ambient
temperature returns to normal.
Leave the player off for an hour
or so, then try again.
Adjust volume to a desired level.
Check wiring connection.
Adjust the installation angle less
than 30 degrees.
Clean the compact disc, or try
to play a new one.
Press the RESET button. Make
Sure the Front panel is properly
fixed into its place.
Insert the antenna cable firmly.
Select a station manually.
12
Solution