Advertisement
4
INSTALL THE LIGHT-BLOCK SHEET. (See figure-5)
Install the light-block sheet around the lens as
shown in the illustration.
(Use the sheet included with the lens.)
Set the light-block sheet, so that the large rounder
side is set over the lens.
5
MOUNT THE LENS COVER. (See figure-6)
When in install the both upper and lower lens cov-
ers, install the light-block sheet so that it should be
placed in the guide slot of the lens cover. If the
installation of the light-block sheet is incorrect, there
will be the space between lens and the lens cover,
so that it will be the cause of leakage of light or the
dust entering at the main cabinet.
1. Insert the upper part lens cover and fix
them with screws A (4 screws).
2. Insert the lower part lens cover and fix them
with screws B. (2 screws).
❋ Figure shown inside of the cabinet.
(D)
(D)
LENS MOTOR
(D)
(D)
B
A WIRE HOLDER
LENS MOTOR LEAD
CONNECTOR " K16B"
LIGHT-BLOCK SHEET
UPPER LENS COVER
A
B
Fig-4
Set the light-block sheet, so that the
large rounder side is set over the lens.
LOWER LENS COVER
Fig-5
A
Fig-6
Advertisement
