Curtis SLG-10 Service Manual

F
ind out more
.
on the web
WILBURCURTIS.COM
Models Included
SLG
CAUTION: Please use
this setup procedure
before attempting to
use this grinder. Failure to follow
the instructions can result in injury
or the voiding of the warranty.
WARNING TO AVOID
SCALDING, Do not
remove brewcone while
brew light is flashing.
C
ISO 9001 REGISTERED
WILBUR CURTIS COMPANY
Montebello, CA 90640
W
ilbur
Service Manual – Low Profile Grinder
Important Safeguards/Conventions
This appliance is designed for commercial use. Any servicing other than cleaning and maintenance should be performed
by an authorized Wilbur Curtis service center.
• Do NOT immerse the unit in water or any other liquid
• To reduce the risk of fire or electric shock, do NOT open top panel. No user serviceable parts inside. Repair should
be done only by authorized service personnel.
• Keep hands and other items away from hot parts of unit during operation.
• Never clean with scouring powders or harsh implements.
Conventions
WARNINGS – To help avoid personal injury
QUICK START & SETUP - SLG
1. Install the grinder on a firm, level counter top in a location where it can be connected to a grounded electrical outlet of
120VAC, rated at 15 amps.
2. Test the unit by running some whole bean coffee through the grinder. If any problems are encountered, refer to the
troubleshooting section complete at www.wilburcurtis.com or call Technical Support at 800-995-0417.
OPERATING INSTRUCTIONS - SLG
The SLG grinder is adjusted at the factory to grind 2 - 2.5 ounces of medium roast coffee.
1. Lift off the clear hopper lid and fill the hopper with whole coffee beans.
2. Place a new filter into your brew cone. Slide the brew cone into the brew cone rails on the grinder.
3. Push the START switch on the front panel. The SLG will start to grind coffee into the brew cone.
4. Wait for the grinder motor to stop before removing the brew cone.
ADJUSTING THE GRINDS
Refer to illustration, page 2. This adjustment may change the amount of ground coffee dispensed.
1. Empty hopper of coffee beans. Run grinder to clear grinding burrs of coffee.
2. Open housing cover to locate adjustment screw (8) and lock nut (7). Loosen lock
nut.
3. Run motor during adjustment. Turning adjustment screw clockwise will result in a
finer grind (if, while turning, you hear the grinding burrs starting to touch, immedi-
ately, back off 1/8th turn). Turning counter clockwise will produce a coarser grind.
4. With a screwdriver holding the adjustment screw in place, tighten the locknut.
5. Run some coffee beans through the machine to check the grind adjustment.
6. Replace front cover on machine.
CHANGING A BROKEN SHEAR DISK
1. Unplug the power cord.
2. Open the hopper and remove any coffee beans, then open the front cover.
3. On the grind motor assembly, take out the two thumb screws (10) and remove the grind cap (6).
4. Pull out the grinding burr/feed worm assembly (2). The inner half of grinding burrs will remain within the housing.
5. Separate the shear cap (5) and shear drive (3). The broken shear disk (4) should fall out from the slot on the drive.
6. Inspect and clean the housing (1) of any coffee or debris. Especially, look for something that could have caused the
shear disk to break.
For the Latest speciFications and inFormation go to www.wiLburcurtis.com
C C
urtis ompany
Important Notes/Cautions – from the factory
, i .
nC
1