Troubleshooting; Specifications - Sanyo ABC-VW24A Instruction Manual

Troubleshooting

Warning
¡If the device is still operating abnormally after inspecting the following, stop using the device to prevent
accidents, unplug the power plug from the wall outlet and consult the place of purchase.
¡Do not attempt to repair at home as this may be dangerous.
Condition
Does not operate.
¡Is the power plug securely in the wall outlet?
Smoke and odors
¡Are the filter and pre-filter installed?
are not removed.
¡Has the plastic protector on the filter been
removed?
¡Is the filter or pre-filter dirty?
¡Is the filter replacement lamp flashing?
¡Is the air inlet dirty and blocked?
The clean ¡Is the air very dirty?
indicator is
¡Are any insecticides or cosmetic devices that
continuously red.
may trigger the sensor being used?
¡Is the sensor sensitivity adjustment slide tab set
to "HIGH"?
The add water ¡Is there water in the tank?
lamp is on.
¡It is time to replace the water.
The add water
lamp is flashing.
¡The electrolyzed water function has not been
used for an extended period of time.
Water is leaking.
¡Has the cap been placed correctly on the tank?
¡Has the electrolyzed water unit been properly
installed?
There is an odor
¡This is from the electrolyzed water and is not a malfunction.
of chlorine.
¡Has the electrolyzed water unit and tank been
The sterile,
electrolytic mist
properly installed?
is not emitted.
¡Is the electrolyzed water button turned "Off"?
¡Is the water level in the electrolyzed water unit
high?
The Electrolyzed
¡The Electrolyzed Water lamp flashes when cleaning the water to maintain its sterilizing
Water lamp is
effect. The Water Cleaning function operates once every 8 hours for about 4 minutes.
flashing.
¡The automatic operation lamp (green) is flashing.
Does not operate
even when the air
is dirty.
¡Is the sensor sensitivity adjustment slide tab set
to "Mid" or "LOW"?
¡Is the air inlet dirty and blocked?

Specifications

Power supply : 120 V / 60 Hz
Current supply : 1.2 A
Net weight : 15.9 lbs (7.2 kg)
Inspect Repair
¡Place the power plug securely in the wall outlet.
¡Install the filter and pre-filter.
¡Remove the plastic protector on the filter.
¡Replace the filter or clean the pre-filter.
¡Clean the air inlet.
¡Ventilate the room.
¡Set the sensor sensitivity adjustment slide tab to
"Mid" or "LOW".
¡Fill the tank with tap water.
¡Remove the tank and replace after waiting 20
seconds.
¡Clean the electrolyzed water unit and replace
the water in the tank.
¡Remove the tank and replace after waiting 20
seconds.
¡Retighten the cap correctly.
¡Install the electrolyzed water unit properly.
¡Ensure that the installation is correct.
¡Press the electrolyzed water button to turn "On".
¡Replace the water in the electrolyzed water unit.
¡The sensor is configuring the air cleanliness
standard. This is not a malfunction.
¡Set the sensor sensitivity adjustment slide tab to
"Mid" or "HIGH".
¡Clean the air inlet.
E-14