Electrolyzed Water Unit/Tank - Sanyo ABC-VW24A Instruction Manual

Cleaning Methods

Electrolyzed Water Unit/Tank

1
Remove the cover, tank, and
electrolyzed water unit.
¡Lift the tank straight up.
Cover
Note:
¡Use a towel to ensure that the floor does not get wet from water attached to the electrolyzed
water unit and tank.
3 Wash the tank and electrolyzed water
cover with water.
¡Rinse clean with water. Use a toothbrush to
remove the dirt if extremely dirty.
5
Wipe off any water and dry completely.
7
Close the cap on the tank and replace.
Note:
¡Do not wash any other components except the tank and electrolyzed water unit. This may
cause an electric shock or malfunction.
¡Do not use detergents. This may cause malfunctions.
E-13
Electrolyzed Water Unit
Tank
[Rear]
Cap
Warning
Always remove the power plug from the wall outlet.
2
Remove the electrolyzed water cover.
¡Remove the cover from both sides (lift to
remove the electrolyzed water cover).
Hook
4 In the event of limescale build up on
the Sterile-Electrolytic Mist Generator,
clean with white vinegar to remove the
limescale. Do not use water as this
may cause the unit to malfunction.
Sterile-Electrolytic
Mist Generator
6
Re-assemble the electrolyzed water
unit and replace.
¡Place the side tabs of the electrolyzed water
unit cover to the bottom and press the hooks
on both sides.
Tab
Hook
8
Replace the cover.
¡Push from above.
Lift
Electrolyzed
Water Cover
Hook
Cotton
Swab
Hooks
Cover