Sandtoft TLE Dry Verge Installation Manual

Table of Contents

Download this manual

Installation guide for Sandtoft TLE Dry Verge

The Sandtoft TLE dry verge system has been specially designed to suit thin

leading edge flat single lap concrete and clay roof tiles (suits batten gauges

from 280 to 345mm).

The system is extremely quick and easy to fit and depending upon the particular

tile, is either closely colour matched or coloured to complement the tiles.

Components:

Eaves closure – suits

both left and right hand

sides

Ridge closure comb

TLE dry verge is compatible with most thin leading edge flat single lap large

format concrete and clay tiles, including the following Sandtoft tiles:

 TLE

 Cassius

 Rivius

Colours:

Terracotta Red/Rustic

Due to different computer monitors/calibrations the images shown may not be an accurate representation of the final products colour.

Right hand verge unit (left

and right handed versions

available)

35 x 4mm stainless

steel screws

(included)

Dark Grey/Antique

Brown

Table of Contents

Do you have a question about the TLE Dry Verge and is the answer not in the manual?

Page 1 35 x 4mm stainless Ridge closure comb steel screws (included) Compatibility: TLE dry verge is compatible with most thin leading edge flat single lap large format concrete and clay tiles, including the following Sandtoft tiles:  TLE  Cassius  Rivius...
Page 2 Installation guide for Sandtoft TLE Dry Verge Before installation please note; The Sandtoft TLE dry verge system is not intended to be waterproof. Rainwater running off the roof at the verge will run through the verge units and drip from the underside of the verge units. To minimise the risk of water staining to the gable wall it is recommended that the verge units are positioned approximately 5mm off the wall.
Page 3 Installation guide for Sandtoft TLE Dry Verge 3) Locate the first verge unit over the eaves closure and click into position. Screw through appropriate fixing hole into the centre of the vertical batten using a 35 x 4mm stainless steel screw (supplied).
Page 4 Installation guide for Sandtoft TLE Dry Verge 5) Before inserting the top course verge units into their final positions locate the ridge closure comb onto the lower edges of each verge unit as shown. This will close the gap between the verge units and the wall.