Desktop Installation - Motorola Cleartone CM5000 Installation Manual

Tetra mobile repeater gateway 380-430 mhz
Hide thumbs Also See for Cleartone CM5000:
Table of Contents

Advertisement

Available languages

Available languages

30

Desktop Installation

The CM5000 may be desktop mounted. The Desktop Station option provides the terminal with the
desk microphone, power supply, desk top tray (without speaker) and external loudspeaker.
A separate data device can be connected via the 7-pin Expansion connector on the rear side
(located above the 20-pin accessory connector as shown in figure 8).
Planning
Planning is the key to fast, easy terminal installation. Before a hole is drilled or a wire is run, inspect
the location and determine how and where you intend to mount the antenna, terminal and
accessories. Plan wire and cable runs to provide maximum protection from pinching, crushing, and
overheating. The installation planning should only be undertaken by persons who are competent
and able to ensure that the complete installation fulfils its regulatory requirements, such as EMC
(Electro Magnetic Compatibility) and IEC (International Electrotechnical Commission).
Installation
1.
Be sure line voltage power is available.
2.
Make sure sufficient air can flow around the terminal to permit adequate cooling.
3.
Choose a flat surface for the desktop tray and external loudspeaker.
4.
Be sure the mounting surface is able to adequately support the weight of the terminal and
tray.
5.
If an outdoor antenna is used choose a location for the terminal as close as possible to the
antenna cable inlet of the building. Make sure that the installation of the surge protector is in
accordance with the manufactures' specifications and safety hints. The line voltage power
supply shall be grounded properly.
CM5000 TETRA Mobile Repeater/Gateway Installation Manual
If an outdoor antenna is used a proper grounded Lightning
Protector with Quarter-Wave Shorting Stub must be
inserted between the outdoor antenna and the transceiver
antenna input. The line voltage power supply shall have a
proper ground connection (refer to IEC61312-1). The installa-
tion must meet the requirements of any and all applicable
local codes and regulations.
INSTALLATION

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents