Setting Device Path - ABB COM600 series 5.1 User Manual

4.7.
36
COM600 series 5.1
Logic Processor User's Manual
Figure 4.6-1 Add Symbol Configuration

Setting device path

To setup Logic Editor to communicate with Logic Processor in COM600:
1. Double-click Device in the Devices Window. The Device Editor opens showing
Communication Settings tab.
2. Select Gateway drop-down button, and click Manage Gateways.
3. Add gateway pointing to IP address of COM600 if not available already.
4. Click Scan Network. The Select Device dialog opens. This dialog shows the
COM600 available at the specified IP address.
5. Select item with the COM600 computer name and click OK. This should set the
active path for Logic Editor to communication with Logic Processor in COM600.
6. Once the active path is set, the Device Communication Settings page should show
up as below. Further downloads can be accomplished by login to device.
1MRS756738
Add_Symbol_Configuration.png