Table of Contents
Advertisement
2. Use the up and down arrows to scroll through the users to select the user to be edited.
Select EDIT.
3. To change the user code, enter a new four digit access code. To move back a
character, use the down arrow. To move forward a character, use the up arrow.
Select SAVE.
4. Next, edit the name for the user. Use the keypad to type a name (up to 8 characters).
The character that is being changed will be underlined. To move back a character, use
the down arrow. To move forward a character, use the up arrow. To select letters,
reference the Alpha/Numeric Chart in the Appendix.
NOTE: Write the name and corresponding user number on the Sensor Location List.
Keep this sheet for reference.
5. Select SAVE.
6. Continue to edit users or choose EXIT.
To Remove a User
1. Use the up and down arrows to scroll through the menu until the Remove User screen
is displayed. Select OK.
2. Use the up and down arrows to scroll through the users to select the user to be
removed. Select REMOVE.
3. The system will confirm that the user has been removed. Select OK.
4. Continue to delete users or choose EXIT.
SET CONSOLE DEVICES
The Base Unit contains a siren and a strobe light. They provide notification of an alarm
occurrence. Although it is not recommended, the siren and strobe can be turned off and
will not operate if an alarm occurs.
1. Start at the main screen.
2. Select MENU or press MAIN MENU on the keypad.
3. Using the keypad, enter the master code.
4. Use the up and down arrows to scroll through the menu until the System Settings
screen is displayed. Select OK.
5. Use the up and down arrows to scroll through the menu until the Set Console Devices
On/Off screen is displayed. Select OK.
6. Using the up and down arrows, scroll to choose between strobe and siren. The screen
will indicate whether the strobe/siren is currently set on or off. To change the status,
select CHANGE.
7. Once all settings are to the user's preference, select BACK.
SET DELAY/INSTANT
Each sensor aside from the Base Unit motion sensor can be reset for Instant which elim-
inates the entry delay. By changing a device to Instant , when the system is armed, an
alarm will take place as soon as the device is tripped.
NOTE: The vibration sensor in the Base Unit and the tamper in every sensor are automat-
ically set to Instant. This setting cannot be changed. The purpose of this setting is to send
a notification if an intruder attempts to disable or destroy the device.
NOTE: To avoid a false alarm, sensors that are likely to be tripped as the user enters and
exits the site to arm/disarm the unit should remain set on delay mode.
1. Start at the main screen.
2. Select MENU or press MAIN MENU on the keypad.
3. Using the keypad, enter the master code.
13
Advertisement
Table of Contents
