Table of Contents
Advertisement
NOTE: Each device has a reset button that must be pressed and released. To
locate the reset button, refer to the instructions for each particular device. Be sure
that batteries are properly installed in each device. Press the reset button now.
5. The screen will indicate that the device has been registered with the following screen.
Only 48 sensors and 6 Key Chain Remotes can be added. If there are no slots avail-
able, the screen will display ALL DEVICES IN USE. To edit the description of the
device, select EDIT. To add another device, select EXIT.
6. To edit the description, use the keypad to type a description (up to 8 characters). The
character that is being changed will be underlined. To move back a character, use the
down arrow. To move forward a character, use the up arrow.
IMPORTANT: Write the device description and corresponding device number on the
Sensor Location List. Keep this sheet for reference. This information will be needed
during the monitoring service enrollment process. The location and descriptions for
each device are critical for the monitoring of the system.
7. Select SAVE.
IMPORTANT: As device changes are made, be sure to contact D
service to make adjustments.
To Edit a Device:
1. Use the up and down arrows to scroll through the menu until the Edit Device screen is
displayed. Select OK.
2. Use the up and down arrows to scroll through the list until the device to be edited is
reached. Select EDIT.
3. To edit the description, use the keypad to type a description (up to 8 characters). The
character that is being changed will be underlined. To move back a character, use the
down arrow. To move forward a character, use the up arrow.
IMPORTANT: Write the device description and corresponding device number on the
Sensor Location List. Keep this sheet for reference. This information will be needed
during the monitoring service enrollment process. The location and descriptions for
each device is critical for the monitoring of the system.
4. Select SAVE.
5. Select EXIT.
To Remove a Device:
1. Use the up and down arrows to scroll through the menu until the Remove Device
screen is displayed. Select OK.
2. Use the up and down arrows to scroll through the list until the device to be removed is
reached. Select REMOVE.
3. The system will indicate that the device has been removed. Select OK.
WALT customer
E
CHANGE MASTER CODE
The master code enables ONLY the master user to make programming changes to the
system as well as arm and disarm. The master code can be changed at any time while the
system is disarmed.
1. Start at the main screen.
2. Select MENU or press MAIN MENU on the keypad.
3. Using the keypad, enter the master code.
4. Use the up and down arrows to scroll through the menu until the System Settings
screen is displayed. Select OK.
5. Use the up and down arrows to scroll through the menu until the Change Master Code
screen is displayed. Select OK.
11
Advertisement
Table of Contents
