Maintenance - Clarke AC7000 Operation & Maintenance Instructions Manual

1. Before emptying the water, switch
off and disconnect from the
power supply. Take care not to tilt
the machine causing water to spill
from the collection tray.
2. Remove the drain cap and plug
from the drain port and let the
water flow out into a container.
3. Once drained, replace the plug
and drain cap and switch back
on.
4. For continuous draining, remove the drain cap and insert a length of 13
mm OD drain hose into the drain port. Position it to discharge at a height
lower than the drain port of the air conditioner which may require raising
the unit above floor level.
• This is likely to be beneficial when operating in DEHUMIDIFYING mode.

MAINTENANCE

CLEANING
WARNING: ALWAYS TURN OFF THE UNIT AND DISCONNECT FROM THE
POWER SUPPLY BEFORE CLEANING.
1. Clean the outside surfaces of the
unit with a duster or a soft, moist
cloth.
• Do not use solvents which could
damage the plastic components.
2. If the air filters are blocked with
dust, the efficiency of the unit will
be reduced. Clean the filters after
approximately two weeks of
regular use.
3. To remove the air filters, grasp the
handhold and slide the rear filters
sideways from the back of the
appliance.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
13