Halfords Deluxe Roof Mount Carrier Fitting Instructions

1
The following operation must be completed before the carrier Position the carrier on the floor and place the cycle onto
is mounted to the vehicle roof bars. The carrier must be the carrier. Raise the clamping arm up to the cycle frame.
adjusted to suit the particular cycle to be carried.
2
7Nm
To adjust the position of the base plate, loosen the four M6 Once in the correct position, tighten the nuts to 7Nm
nuts that are situated either side of the longitudinal bar. and fit the carrier to the vehicle.
Offer the clamping arm to the frame of your cycle by sliding
the base unit along the longitudinal bar.
3
Secure the Front of the carrier by releasing the quick release release handles to clamp the carrier to the roofbar.
handles. Rotate the handles anti-clockwise so the L-Shaped The tension can be set by turning the handles clockwise,
Clamps can be freely attached around the roofbar. Take care checking that the quick release handles will close on
to ensure the clamps are located in the slots. Close the quick each full rotation.
4
A B
Secure the carrier to the other roof bar by unlocking the
quick release handle. Rotate the quick release handle
anti-clockwise so that the swing arm can be freely
rotated out of the way.
5
B C
A
Slide the bracket to the point at which the carrier crosses the and close the handle to clamp the carrier to the roof bar.
roof bar and rotate the arm around underside of the roof bar. The tension may be set by turning the handle clockwise,
Fit the head of the coach bolt into the notch of the swing checking that the quick release handle will close on each
arm. Push the coach bolt as far as possible into the notch full rotation.
6
C
To make fitting of the cycle easier, secure the front wheel
using the 52cm strap. Warning: Ensure the strap is inserted
through the cambuckle in the correct direction.
7
Release the jaws of the clamping assembly by unlocking,
lifting the handle and rotating it anti-clockwise.
The clamp may be unscrewed and reversed to provide
either left or right access.
8
Lift your cycle onto the carrier ensuring both tyres are
positioned centrally on the tyre locators.