Loading Paper In The Rear Paper Feed - Epson ET-4700 Series User Manual
Hide thumbs
Also See for ET-4700 Series:
- Quick start manual (4 pages) ,
- User manual (292 pages) ,
- Installation manual
Table of Contents
Advertisement
User's Guide
Loading Paper in the Rear Paper Feed
1. Pull out the paper support.
2. Slide the edge guides.
3. Load paper at the center of the paper support with the printable side facing up.
Important:
c
❏ Do not load more than the maximum number of sheets specified for the paper. For plain paper, do not load
above the line just under the
❏ Load paper short edge first. However, when you have set the long edge as the width of the user defined size,
load paper long edge first.
Preparing the Printer
d
symbol inside the edge guide.
49
Advertisement
Table of Contents
Need help?
Do you have a question about the ET-4700 Series and is the answer not in the manual?
Questions and answers
I have an Epson ET-4700. I keep getting a paper jam under the print head at the start of printing on the left side of the page. How do I check this out?
A rubber band got pulled into the paper feeder and I got an E-01 message. I opened the front of the printer and pulled the rubber band out from the rollers, but some of it may remain. After restarting the printer, the E-01 message remains and I cannot print or scan. Is there any way to find and remove the remaining piece of rubber.
I have a rear paper jam, how do I open the printer at the back?