Introduction - Assa Abloy VingCard Allure User Manual

1. Introduction

Allure is a locking and room status system with modular architecture. Several configurations
are possible, and Figure 1 shows all possible connections to the main control unit; an in-wall
mounted junction box which also contains an RFID lock controller unit, LCU 6333/LCU 6334.
Chapter 2
give other information about the different parts.
maintenance while the
Allure parts and also for the room bus cable etc. Note: The Allure product range also includes
the below items
a power supply with an input of 100-240V~50/60 Hz 0,5A and an output of 12 VDC, 1A
(electric strikes may however need a separate power supply suitable for the
power consumption of the strike)
a doorbell which is constructed to work on 12VDC, 1A to utilize the same power
Note: Some of the parts in Figure 1 are for future use; ask Product Marketing for details.
1)
'EMS' are three transistor outputs which give a signal based on what card that is presented
at the LCU (EMS 1 is triggered at 'guest first entry'; EMS 2 is triggered at 'guest normal entry';
EMS 3 is triggered at 'staff entry')
2) The room bus cable is a cable inside the rooms to which wired room panels, GPIO modules and future
modules can be connected. There is no limitation in the number of items that can be connected to the
room bus cable.
ASSA ABLOY Hospitality
describes mounting and connection of the different Allure parts, while
Appendix gives a quick reference of technical data for the different
Attention: Observe precautions for handling;
electrostatic sensitive devices.
Chapter 8 describes troubleshooting and
Figure 1
9
chapters 3-7
66 1100 005-11