To Reset The Tamper Switch; To Power Open An Access Panel; To Emergency Open A Door Communication Unit - Assa Abloy VingCard Allure User Manual

8.3 To reset the tamper switch

If the tamper switch in enabled and someone tries to remove the access panel,
the tamper switch will go off. The access panel will start flashing red and will
not accept cards. To reset the tamper switch:
1. Open the locking mechanism on the back frame for the access panel;
2. Remove the access panel from the back frame.
3. Connect the service PC (with Lock Service 3G installed) and perform any
4. Snap the access panel onto the back frame again and push down
5. Present a valid staff card at the access panel and make sure that

8.4 To power open an access panel

If the power at an access panel is too low so that the door cannot open when a
card is presented at the access panel, a service PC with Lock Service 3G can be
used for power opening (see Quick reference guide Lock Service 3G for details)
of the access panel.

8.5 To emergency open a door communication unit

For installations where Allure Grand access panel is used in combination with
door communication unit (see
emergency opened by the cable shown in Figure 79 in case all battery warnings have
been ignored and no mechanical override solution such as cylinder is present. The
cable can be plugged into any USB compatible unit (laptop, power bank, charger etc).
Pos
1
2
ASSA ABLOY Hospitality
see Figure 77.
valid communication with Lock Service 3G (see Quick reference guide Lock
Service 3G for details), e.g. set the time or make a parameter read-out.
the locking mechanism according to
the door opens.
Description
Connector, plug, USB A
Connector, DC plug, 5.5x2.1xL23mm, molding style, spring contacts
Figure 78.
section 2.5 for more information), the latter can be
Figure 79
50
Table 8
66 1100 005-11