Hitachi Compute Rack 220H Getting Started Manual page 34

Rear side
Figure 2-6: CR 220H rear side overview
Table 2-6: CR 220H rear side components
Location Name
1 Power supply slots
2 AC connector
3 PCI slots
4 Power supply LED
USB connectors
5
(rear side)
Network interface
6
connectors 1, 2
Management
7 interface
connector
Serial interface
8
connector (COM0)
9 VGA connector
10 NMI switch
SERVICE switch
11
with SERVICE LED
12 Power LED
2-8
1 2
4 5
State
-
-
-
Green-Blink
Green-On
Amber-Blink
Amber-On
-
-
-
-
-
-
Blue-On
Green-On
Hitachi Compute Rack 220H Getting Started Guide
3
6 7 8 9 10
A power supply can be installed to a power supply slot. The
slot numbers are 1, 2 from left to right.
Connect an AC cable to the AC connector.
A PCI Express board can be installed to a PCI slot (PCI).
AC power is supplied / Stand-by state (AC cable is connected,
POWER LED switch is OFF)
Power is ON / Normal operation (POWER LED switch is ON)
Warning status (over-temperature)
Errors occurred (Failure, AC cable has been disconnected, or
other reason)
Connect a keyboard and a mouse. You can also connect USB
devices.
Connectors to connect LAN cables. Network interface
connector numbers are 1 and 2 from right to left.
Connect the management interface connector to a system
console terminal using a LAN cable when you use the remote
management function.
For the details of the remote management function, see
Remote Management User's Guide.
You can use this connector to connect a device such as a
modem that uses a serial interface.
Connect a computer display to the VGA connector.
When you press the NMI switch, NMI is issued and the system
will be forcibly shut down.
Not for use. Do not press this switch.
The SERVICE LED turns on when a SERVICE switch either on
the front side or the rear side is pressed.
Power is ON / Normal operation (POWER switch is ON)*
Overview
1 2
11 12 13
Description