DEMA SQUIRT DRAIN UNIT Manual
  1. Manuals
  2. Brands
  3. DEMA Manuals
  4. Dispenser
  5. SQUIRT DRAIN UNIT
  6. Manual

DEMA SQUIRT DRAIN UNIT Manual

Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

Overview
The Squirt is a chemical dispenser with a programmable timer designed primarily for dispensing chemicals into
drains. Its most clear intended use is for drain applications when a degreaser is needed in the drain daily, or every
other day. The timer is programmable to run up to 8 events that can be set for a specified amount of time to run the
pump.
Warnings
Installation of DEMA products must meet all applicable electrical codes and regulations established
by national, city, county, parish, provincial or other agencies. It is possible that electrical codes and
regulations require that a certified electrical contractor or engineer perform the electrical installation.
For questions, contact a certified electrician.
ALL ELECTRICAL POWER MUST BE TURNED OFF TO THE DISPENSER AND TO
THE APPLIED MACHINE.
All installations must conform to local plumbing codes and use approved backflow prevention
devices. A pressure indicating tee is to be installed with existing faucets according to local
plumbing codes in the state of Wisconsin and any other state that requires the use of a pressure
indicating tee.
ALWAYS WEAR PROTECTIVE CLOTHING AND EYEWEAR WHEN WORKING WITH
CHEMICAL PRODUCTS.
I-984
Rev. M-43434
11/10/17
DEMA
SQUIRT DRAIN UNIT
Page 1 of 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SQUIRT DRAIN UNIT and is the answer not in the manual?

Questions and answers

Related Manuals for DEMA SQUIRT DRAIN UNIT

Summary of Contents for DEMA SQUIRT DRAIN UNIT

  • Page 1 Warnings Installation of DEMA products must meet all applicable electrical codes and regulations established by national, city, county, parish, provincial or other agencies. It is possible that electrical codes and regulations require that a certified electrical contractor or engineer perform the electrical installation.

  • Page 2: Specifications

    Specifications Packing List 25.69.8 30.41 25.20.1 SWITCHING 20’ ¼” SCREW 81.312.1 I984 SQUIRT POWER POWER TUBE INST. DRAIN SUPPLY ADAPTER TUBE TUBING ANCHOR STIFFENER SHEET UNIT (115-240 VAC) 2500 25.68.20 OMIT 81.231.1 2501 25.160.20 25.236.02 81.231.4 2502 25.68.20 25.19.2 81.231.1 2503 25.68.20 OMIT...

  • Page 3: Installation

    Installation Mount the unit no higher than 6 feet from the chemical container. Take into account the proximity to the chemical, drain, and power for the unit. Use the included screw and anchor kit to secure the mounting bracket to the wall and then mount the unit on the wall.

  • Page 4: Wiring Diagram

    B. Programming the Dispensing Events: Up to 8 independent dispensing events can be programmed 1. Press and release the TIMER button to enter the programming mode. The event number will be in the bottom left corner. Note: To program a full event, a pump start time and stop time will have to be programmed.

  • Page 5: Troubleshooting

    Rubber and synthetic rubber parts such as “O”-rings, diaphragms, PVC tubing, and gaskets are considered expendable and are not covered under warranty. This warranty is extended only to the original buyer of DEMA products. If products are altered or repaired without prior approval of DEMA, this warranty is void.

Table of Contents