Advertisement
Table of Contents
Overview
The squirt DC is a battery operated chemical dispenser with a programmable timer designed
primarily for dispensing chemical into drains. Its intended use is for drain applications when a
degreaser is needed in the drain regularly. The timer is programmable up to 8 events and can be
set for specified time periods to run the pump.
Warnings
Installation of DEMA products must meet all applicable electrical codes and
regulations established by national, city, county, parish, provincial or other
agencies. It is possible that electrical codes and regulations require that a certified
electrical contractor or engineer perform the electrical installation. For questions,
contact a certified electrician.
ALL ELECTRICAL POWER MUST BE TURNED OFF TO THE
DISPENSER AND TO THE APPLIED MACHINE.
All installations must conform to local plumbing codes and use approved
backflow prevention devices. A pressure indicating tee is to be installed with
existing faucets according to local plumbing codes in the state of Wisconsin and
any other state that requires the use of a pressure indicating tee.
ALWAYS WEAR PROTECTIVE CLOTHING AND EYEWEAR WHEN
WORKING WITH CHEMICAL PRODUCTS.
I-1048
Rev. A-39406
11/27/13
SQUIRT DC
Page 1 of 7
Advertisement
Table of Contents
Related Manuals for DEMA SQUIRT DC
Summary of Contents for DEMA SQUIRT DC
- Page 1 SQUIRT DC Overview The squirt DC is a battery operated chemical dispenser with a programmable timer designed primarily for dispensing chemical into drains. Its intended use is for drain applications when a degreaser is needed in the drain regularly. The timer is programmable up to 8 events and can be set for specified time periods to run the pump.
-
Page 2: Specifications
Specifications Packing List SQUIRT SPLIT DEMA CABLE DC DRAIN ¼” TUBING PICK UP SQUEEZE TUBE TIES (8) UNIT TUBE 81-231-1 2504 25-220-1 81-16-3 25-68-20 (LDPE) 81-312-1 (EPDM, JACO) 25-160-20 (SUPER 81-231-4 2505 25-220-1 81-16-3 81-312-1 TUBE) (EPDM, CONE) Operational Requirements... -
Page 3: Installation
Parts List PART NO. DESCRIPTION 81-278-1 PUMP BLANK COVER 81-226-5 PUMP HEAD ASSY. 81-220-1 DRIVE SHAFT ADAPTER 81-311-2 118 RPM MOTOR ASSEMBLYT 25-212-2 (8) POSITION D-CELL BATTERY HOLDER 25-20-3 TIMER 44-116-2 #8 X 3/8” HI/LO SCREW 81-18-1 #6 X 3/8” HI/LO SCREW 83-16-2 VELCRO PATCH Installation... -
Page 4: Operation
Squeeze Tube Installation Install the squeeze tube by removing the pump cover by depressing the tab on the front of the unit. (1) Place one end of the squeeze tube on the left side of the pump in the slot provided. (2) Wrap the squeeze tube around the rollers of the pump. - Page 5 A. Press the reset button before programming. Note: If a mistake is made during the programming, simply push the reset button and start over. 12 Hour or 24 Hour (Military) Mode 1. Hold the “Clock” button down for 5 seconds or more to change back & forth to between the 12 &...
-
Page 6: Troubleshooting
Product Warranty DEMA products are warranted against defective material and workmanship under normal use and service for one year from the date of manufacture. This limited warranty does not apply to any products that have a normal life shorter than one year or failure and damage caused by chemicals, corrosion, physical abuse, or misapplication. - Page 7 DEMA products. If products are altered or repaired without prior approval of DEMA, this warranty is void. Defective units or parts should be returned to the factory with transportation prepaid. If inspection shows them to be defective, they will be repaired or replaced without charge, F.O.B. factory. DEMA assumes no liability for damages.
Need help?
Do you have a question about the SQUIRT DC and is the answer not in the manual?
Questions and answers